P0705 on Audi: Symptoms, Causes & Fix
Official technical diagnostic wire for fault code P0705 specifically affecting Audi vehicles (A4, A6, Q5, Q7, A3).
Select Your Audi Model for P0705:
1. Common Symptoms on Audi Vehicles
When Audi Engine Control Modules (ECM) trigger fault code P0705, drivers typically report:
2. Root Causes on Audi Engines
Historical diagnostic claims across Audi engines point to the following failure distribution:
3. Step-by-Step Fix Protocol for Audi
Move gear selector through all positions while monitoring scan tool TR PID to see which gear positions fail to register. on Audi engines.
Ensure the mechanical shift linkage fully clicks the transmission lever into the physical detent for Park and Neutral. on Audi engines.
Use multimeter to check continuity across switch pins in Park, Reverse, Neutral, and Drive. on Audi engines.
Loosen mounting bolts, use alignment pin to align sensor slot with transmission shaft in Neutral, torque bolts, or install new OEM sensor. on Audi engines.
Clear DTCs and confirm engine starts in Park and Neutral, reverse lights activate, and gear display is accurate. on Audi engines.
Equipment for Diagnosing Audi (P0705)
Audi OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Audi.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
4. Audi P0705 Frequently Asked Questions
What does code P0705 mean on a Audi?
On Audi vehicles, P0705 indicates that the Engine Control Module (ECM) detected transmission range sensor circuit malfunction (prndl input). This typically points to Misaligned or faulty Transmission Range Sensor / Neutral Safety Switch (NSS) or Corroded or water-logged connector on transmission side.
Can I continue driving my Audi with code P0705?
Caution. Vehicle may not start in Park, backup lights may not work, and transmission may lock in Limp Mode. Because this code carries a High severity rating on Audi powertrains, we recommend scanning live data values promptly to prevent secondary damage.
How much does it cost to fix code P0705 on a Audi?
Estimated DIY parts cost ranges from $120 - $450 (DIY: $40 - $160), while professional shop repairs at an authorized Audi dealership or independent specialist typically range from $180 to $380 including diagnostic labor.