MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0452 on Dodge: Symptoms, Causes & Fix

EVAP Pressure Sensor / Switch Low Input

Official technical diagnostic wire for fault code P0452 specifically affecting Dodge vehicles (Charger, Challenger, Durango, Hornet, Journey).

Sensor Voltage Ref
0.1V – 5.0V Ref
Dodge Factory Standard
CAN Bus Speed
500 kbps CAN-FD
ISO 15765-4 Diagnostic Bus
Drivability Status
Drivable (Short Trip)
Low urgency level
Est. Repair Cost
$120 - $350
Parts & Labor DIY
Model-Specific Diagnostic Wires

Select Your Dodge Model for P0452:

4 Models Available

1. Common Symptoms on Dodge Vehicles

When Dodge Engine Control Modules (ECM) trigger fault code P0452, drivers typically report:

Check Engine Light on on Dodge Powertrains
Failed emissions test on Dodge Powertrains

2. Root Causes on Dodge Engines

Historical diagnostic claims across Dodge engines point to the following failure distribution:

55%
Faulty Fuel Tank Pressure (FTP) sensor (Dodge OEM Part)
25%
Short to ground in sensor signal wire (Dodge OEM Part)
12%
Corroded connector at fuel tank (Dodge OEM Part)

3. Step-by-Step Fix Protocol for Dodge

01
Scan and Record Freeze Frame Telemetry

Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0452 to note engine RPM, load, and voltage when the fault triggered. on Dodge engines.

Required Tool: OBD-II Scanner
02
Inspect Related Wiring Harness & Connectors

Inspect the electrical connector and wiring harness related to P0452 for chafing, corrosion, moisture, or pin push-out. on Dodge engines.

Required Tool: Flashlight, Multimeter
03
Test Component Resistance & Voltage Supply

Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on Dodge engines.

Required Tool: Digital Multimeter
04
Replace Defective Component

Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on Dodge engines.

Required Tool: Hand Tool Socket Set, Torque Wrench
05
Clear Trouble Codes & Complete Drive Cycle

Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on Dodge engines.

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Dodge (P0452)

Prime Fast Delivery & Verified Fitment
EVAP Seal Replacement

OEM Tethered Fuel Gas Cap with O-Ring

4.7 / 5.0 (Direct Fit)

Tight-sealing factory fuel cap resolves common EVAP small/large leak codes without workshop visits.

$17 – $26 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for DodgeVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

4. Dodge P0452 Frequently Asked Questions

What does code P0452 mean on a Dodge?

On Dodge vehicles, P0452 indicates that the Engine Control Module (ECM) detected evap pressure sensor / switch low input. This typically points to Faulty Fuel Tank Pressure (FTP) sensor or Short to ground in sensor signal wire.

Can I continue driving my Dodge with code P0452?

Yes. Fuel tank pressure sensor shorted to ground. Because this code carries a Low severity rating on Dodge powertrains, we recommend scanning live data values promptly to prevent secondary damage.

How much does it cost to fix code P0452 on a Dodge?

Estimated DIY parts cost ranges from $120 - $350, while professional shop repairs at an authorized Dodge dealership or independent specialist typically range from $180 to $380 including diagnostic labor.