P0092 on RAM: Symptoms, Causes & Fix
Official technical diagnostic wire for fault code P0092 specifically affecting RAM vehicles (1500, 2500, 3500, TRX).
Select Your RAM Model for P0092:
1. Common Symptoms on RAM Vehicles
When RAM Engine Control Modules (ECM) trigger fault code P0092, drivers typically report:
2. Root Causes on RAM Engines
Historical diagnostic claims across RAM engines point to the following failure distribution:
3. Step-by-Step Fix Protocol for RAM
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0092 to note engine RPM, load, and voltage when the fault triggered. on RAM engines.
Inspect the electrical connector and wiring harness related to P0092 for chafing, corrosion, moisture, or pin push-out. on RAM engines.
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on RAM engines.
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on RAM engines.
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on RAM engines.
Equipment for Diagnosing RAM (P0092)
RAM OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for RAM.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
4. RAM P0092 Frequently Asked Questions
What does code P0092 mean on a RAM?
On RAM vehicles, P0092 indicates that the Engine Control Module (ECM) detected fuel pressure regulator 1 control circuit high. This typically points to Short to 12V power in harness or Failed regulator solenoid.
Can I continue driving my RAM with code P0092?
No. Short to power in regulator circuit. Because this code carries a High severity rating on RAM powertrains, we recommend scanning live data values promptly to prevent secondary damage.
How much does it cost to fix code P0092 on a RAM?
Estimated DIY parts cost ranges from $120 - $350, while professional shop repairs at an authorized RAM dealership or independent specialist typically range from $180 to $380 including diagnostic labor.