P2119 on Subaru: Symptoms, Causes & DIY Fix
Official technical diagnostic wire for fault code P2119 (P2119: Throttle Actuator Control Throttle Body Range/Performance) specifically affecting Subaru vehicles (Outback, Forester, Crosstrek, WRX, Ascent).
1. Symptoms of P2119 on Subaru
When the Engine Control Module (ECM/PCM) on your Subaru logs fault code P2119, drivers commonly observe:
2. Most Likely Causes on Subaru
Historical warranty claims and technical repair bulletins for Subaru point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Subaru
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P2119 is static or intermittent. on Subaru vehicles (Outback, Forester).
Visually inspect the physical component (Throttle Plate Carbon Jamming), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on Subaru vehicles (Outback, Forester).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on Subaru vehicles (Outback, Forester).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on Subaru vehicles (Outback, Forester).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on Subaru vehicles (Outback, Forester).
4. Subaru P2119 FAQs
What causes code P2119 to trigger on a Subaru?
On Subaru vehicles, P2119 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Throttle Plate Carbon Jamming) or Wiring harness abrasion, loose terminal pin, or ground voltage float. Factory sensor degradation or wiring harness wear near the engine bay are common factors.
Can I safely drive my Subaru with code P2119?
Caution. Limited operation permitted only to reach a nearby repair facility or backup critical personal files. Given that P2119 carries a High severity rating on Subaru vehicles, we advise performing diagnostic scanning via the OBD-II port before extended driving.
How much does it cost to fix P2119 on a Subaru?
DIY replacement parts typically range between $200 - $500 (DIY: $60 - $160). If serviced at an authorized Subaru dealership, expect an additional $120–$250 in professional labor based on their $115/hr hourly rate.