MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0087 on Tesla: Symptoms, Causes & Fix

Fuel Rail/System Pressure - Too Low

Official technical diagnostic wire for fault code P0087 specifically affecting Tesla vehicles (Model 3, Model Y, Model S, Model X, Cybertruck).

Sensor Voltage Ref
0.1V – 5.0V Ref
Tesla Factory Standard
CAN Bus Speed
500 kbps CAN-FD
ISO 15765-4 Diagnostic Bus
Drivability Status
Not Recommended
Critical urgency level
Est. Repair Cost
$150 - $1,200 (DIY: $80 - $350)
Parts & Labor DIY
Model-Specific Diagnostic Wires

Select Your Tesla Model for P0087:

5 Models Available

1. Common Symptoms on Tesla Vehicles

When Tesla Engine Control Modules (ECM) trigger fault code P0087, drivers typically report:

Check Engine Light illuminated on Tesla Powertrains
Engine cranks but takes a long time to start (hard starting) on Tesla Powertrains
Noticeable lack of engine power or acceleration hesitation on Tesla Powertrains
Engine sputtering, surging, or dying under heavy throttle on Tesla Powertrains
Accompanying misfire codes (P0300, P0301-P0306) on Tesla Powertrains

2. Root Causes on Tesla Engines

Historical diagnostic claims across Tesla engines point to the following failure distribution:

55%
Failing High-Pressure Fuel Pump (HPFP) (Tesla OEM Part)
25%
Clogged fuel filter or restricted in-tank low-pressure fuel pump (LPFP) (Tesla OEM Part)
12%
Faulty fuel rail pressure sensor (FRP) reading incorrectly (Tesla OEM Part)
8%
Clogged or leaking fuel injector stuck open (Tesla OEM Part)
8%
Faulty fuel pressure regulator or damaged fuel supply lines (Tesla OEM Part)

3. Step-by-Step Fix Protocol for Tesla

01
Scan Live Data for Desired vs Actual Fuel Rail Pressure

Connect an OBD-II scan tool and inspect live Mode $01 telemetry for Fuel Rail Pressure (FRP). Compare actual pressure against the ECU's desired setpoint during idle and 2,500 RPM revs. on Tesla engines.

Required Tool: OBD-II Scanner with Live Data
02
Test In-Tank Low Pressure Supply

Verify the low-pressure lift pump is delivering 55–75 PSI to the HPFP using a mechanical fuel pressure gauge on the Schrader valve. on Tesla engines.

Required Tool: Fuel Pressure Gauge Kit
03
Inspect Fuel Rail Pressure Sensor & Wiring

Check the 3-wire FRP sensor harness for 5V reference, ground, and signal voltage (typically 0.5V at key-on to 4.5V at peak pressure). on Tesla engines.

Required Tool: Digital Multimeter, Backprobe Pins
04
Replace High-Pressure Fuel Pump (HPFP) or Fuel Filter

If low-pressure feed is verified but rail pressure remains under threshold, replace the camshaft-driven HPFP and follower. on Tesla engines.

Required Tool: Socket Set, Torx Bits, Fuel Line Disconnect Tool
05
Clear Codes and Perform Extended Drive Cycle

Clear DTC memory with scanner, start engine, check for fuel leaks, and drive for 15 minutes to verify fuel pressure monitors pass. on Tesla engines.

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Tesla (P0087)

Prime Fast Delivery & Verified Fitment
Direct-Fit Replacement Part

Tesla OEM Replacement Sensor

4.7 / 5.0 (Verified Fit)

Direct-fit replacement assembly engineered to OEM tolerances for Tesla.

$45 – $95 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for TeslaVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

4. Tesla P0087 Frequently Asked Questions

What does code P0087 mean on a Tesla?

On Tesla vehicles, P0087 indicates that the Engine Control Module (ECM) detected fuel rail/system pressure - too low. This typically points to Failing High-Pressure Fuel Pump (HPFP) or Clogged fuel filter or restricted in-tank low-pressure fuel pump (LPFP).

Can I continue driving my Tesla with code P0087?

No. Low fuel pressure causes severe engine hesitation, misfires, stalling at speed, and lean detonation. Because this code carries a Critical severity rating on Tesla powertrains, we recommend scanning live data values promptly to prevent secondary damage.

How much does it cost to fix code P0087 on a Tesla?

Estimated DIY parts cost ranges from $150 - $1,200 (DIY: $80 - $350), while professional shop repairs at an authorized Tesla dealership or independent specialist typically range from $180 to $380 including diagnostic labor.