P0304 on Ford: Symptoms, Causes & DIY Fix
Official technical diagnostic wire for fault code P0304 (P0304: Cylinder 4 Misfire Detected) specifically affecting Ford vehicles (F-150, F-250 Super Duty, Explorer, Mustang, Escape, Bronco, Bronco Sport, Ranger, Maverick, Expedition, Mustang Mach-E).
1. Symptoms of P0304 on Ford
When the Engine Control Module (ECM/PCM) on your Ford logs fault code P0304, drivers commonly observe:
2. Most Likely Causes on Ford
Historical warranty claims and technical repair bulletins for Ford point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Ford
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P0304 is static or intermittent. on Ford vehicles (F-150, F-250 Super Duty).
Visually inspect the physical component (Cylinder 4 Spark Plug / Wiring), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on Ford vehicles (F-150, F-250 Super Duty).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on Ford vehicles (F-150, F-250 Super Duty).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on Ford vehicles (F-150, F-250 Super Duty).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on Ford vehicles (F-150, F-250 Super Duty).
4. Ford P0304 FAQs
What causes code P0304 to trigger on a Ford?
On Ford vehicles, P0304 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Cylinder 4 Spark Plug / Wiring) or Wiring harness abrasion, loose terminal pin, or ground voltage float. Factory sensor degradation or wiring harness wear near the engine bay are common factors.
Can I safely drive my Ford with code P0304?
No. Immediate shutdown / repair required to prevent permanent hardware destruction or total system lockup. Given that P0304 carries a Critical severity rating on Ford vehicles, we advise performing diagnostic scanning via the OBD-II port before extended driving.
How much does it cost to fix P0304 on a Ford?
DIY replacement parts typically range between $100 - $450 (DIY: $25 - $90). If serviced at an authorized Ford dealership, expect an additional $120–$250 in professional labor based on their $120/hr hourly rate.