MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0155 on Hyundai: Symptoms, Causes & Fix

O2 Sensor Heater Circuit Malfunction (Bank 2 Sensor 1)

Official technical diagnostic wire for fault code P0155 specifically affecting Hyundai vehicles (Elantra, Sonata, Tucson, Santa Fe, Palisade).

Sensor Voltage Ref
0.1V – 5.0V Ref
Hyundai Factory Standard
CAN Bus Speed
500 kbps CAN-FD
ISO 15765-4 Diagnostic Bus
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. Repair Cost
$120 - $350 (DIY: $45 - $120)
Parts & Labor DIY
Model-Specific Diagnostic Wires

Select Your Hyundai Model for P0155:

6 Models Available

1. Common Symptoms on Hyundai Vehicles

When Hyundai Engine Control Modules (ECM) trigger fault code P0155, drivers typically report:

Check Engine Light on immediately after cold start on Hyundai Powertrains
Slightly increased cold-start emissions on Hyundai Powertrains
No major driving performance issues once engine reaches full operating temperature on Hyundai Powertrains

2. Root Causes on Hyundai Engines

Historical diagnostic claims across Hyundai engines point to the following failure distribution:

55%
Burnt-out heating element inside the Bank 2 Sensor 1 O2 sensor (Hyundai OEM Part)
25%
Blown O2 heater fuse in under-hood fuse block (Hyundai OEM Part)
12%
Corroded or broken heater power/ground wiring (Hyundai OEM Part)
8%
Faulty heater driver circuit in the PCM (Hyundai OEM Part)

3. Step-by-Step Fix Protocol for Hyundai

01
Check O2 Heater Fuse

Inspect the O2 HTR fuse in the engine fuse box with a test light or multimeter. on Hyundai engines.

Required Tool: Fuse Puller, Test Light
02
Test Heater Resistance on Bank 2 Sensor 1

Unplug the sensor connector and measure resistance between the two heater pins. An open circuit (infinite ohms / OL) confirms a dead internal heater. on Hyundai engines.

Required Tool: Digital Multimeter
03
Replace Bank 2 Upstream O2 Sensor

Remove faulty sensor and install a new OEM oxygen sensor with built-in heater. on Hyundai engines.

Required Tool: 22mm O2 Sensor Socket, Ratchet
04
Clear Codes and Perform Cold Start Verification

Clear DTCs and allow engine to cool down, then restart to confirm P0155 does not return. on Hyundai engines.

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Hyundai (P0155)

Prime Fast Delivery & Verified Fitment
Direct-Fit Replacement Part

Hyundai OEM Replacement Sensor

4.7 / 5.0 (Verified Fit)

Direct-fit replacement assembly engineered to OEM tolerances for Hyundai.

$45 – $95 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for HyundaiVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

4. Hyundai P0155 Frequently Asked Questions

What does code P0155 mean on a Hyundai?

On Hyundai vehicles, P0155 indicates that the Engine Control Module (ECM) detected o2 sensor heater circuit malfunction (bank 2 sensor 1). This typically points to Burnt-out heating element inside the Bank 2 Sensor 1 O2 sensor or Blown O2 heater fuse in under-hood fuse block.

Can I continue driving my Hyundai with code P0155?

Yes. The sensor will take longer to warm up, causing brief open-loop fuel delay on cold starts. Because this code carries a Medium severity rating on Hyundai powertrains, we recommend scanning live data values promptly to prevent secondary damage.

How much does it cost to fix code P0155 on a Hyundai?

Estimated DIY parts cost ranges from $120 - $350 (DIY: $45 - $120), while professional shop repairs at an authorized Hyundai dealership or independent specialist typically range from $180 to $380 including diagnostic labor.