P2135 on Toyota: Symptoms, Causes & DIY Fix
Official technical diagnostic wire for fault code P2135 (P2135: Throttle/Pedal Position Sensor/Switch A / B Voltage Correlation) specifically affecting Toyota vehicles (Camry, Camry Hybrid, Camry TRD, Corolla, RAV4, Tacoma, Highlander, Tundra, Prius, Grand Highlander, 4Runner, Crown, Land Cruiser).
1. Symptoms of P2135 on Toyota
When the Engine Control Module (ECM/PCM) on your Toyota logs fault code P2135, drivers commonly observe:
2. Most Likely Causes on Toyota
Historical warranty claims and technical repair bulletins for Toyota point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Toyota
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P2135 is static or intermittent. on Toyota vehicles (Camry, Camry Hybrid).
Visually inspect the physical component (Accelerator Pedal Sensor / TPS), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on Toyota vehicles (Camry, Camry Hybrid).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on Toyota vehicles (Camry, Camry Hybrid).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on Toyota vehicles (Camry, Camry Hybrid).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on Toyota vehicles (Camry, Camry Hybrid).
4. Toyota P2135 FAQs
What causes code P2135 to trigger on a Toyota?
On Toyota vehicles, P2135 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Accelerator Pedal Sensor / TPS) or Wiring harness abrasion, loose terminal pin, or ground voltage float. Factory sensor degradation or wiring harness wear near the engine bay are common factors.
Can I safely drive my Toyota with code P2135?
No. Immediate shutdown / repair required to prevent permanent hardware destruction or total system lockup. Given that P2135 carries a Critical severity rating on Toyota vehicles, we advise performing diagnostic scanning via the OBD-II port before extended driving.
How much does it cost to fix P2135 on a Toyota?
DIY replacement parts typically range between $180 - $480 (DIY: $50 - $140). If serviced at an authorized Toyota dealership, expect an additional $120–$250 in professional labor based on their $110/hr hourly rate.