P0204 on Acura Integra
Factory diagnostic protocol and troubleshooting wire for fault code P0204 specifically for the Acura Integra (2023–2026, 1.5L VTEC Turbo (200HP) / 2.0L VTEC Turbo (Type S 320HP)).
1. Symptoms of P0204 on Acura Integra
When the Engine Control Module (ECM/PCM) on your Acura Integra (1.5L VTEC Turbo (200HP) / 2.0L VTEC Turbo (Type S 320HP)) logs fault code P0204, drivers commonly observe:
2. Most Likely Causes on Acura Integra
Historical warranty claims and technical repair bulletins for Acura Integra point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Acura Integra
Measure resistance across pins (12–16 ohms). on the Acura Integra equipped with 1.5L VTEC Turbo (200HP) / 2.0L VTEC Turbo (Type S 320HP).
Check that ECM pulse reaches the connector. on the Acura Integra equipped with 1.5L VTEC Turbo (200HP) / 2.0L VTEC Turbo (Type S 320HP).
Replace the faulty injector with OEM unit. on the Acura Integra equipped with 1.5L VTEC Turbo (200HP) / 2.0L VTEC Turbo (Type S 320HP).
Clear DTC memory and confirm smooth operation. on the Acura Integra equipped with 1.5L VTEC Turbo (200HP) / 2.0L VTEC Turbo (Type S 320HP).
Equipment for Diagnosing Acura Integra (P0204)
Acura Integra OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Acura Integra.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Acura Integra
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Acura Integra:
4. Acura Integra P0204 FAQs
What causes code P0204 to trigger on a Acura Integra?
On the Acura Integra (1.5L VTEC Turbo (200HP) / 2.0L VTEC Turbo (Type S 320HP)), P0204 is most frequently caused by Faulty Cylinder 4 fuel injector or Broken wiring harness.
Where is the OBD-II port located on my Acura Integra?
On the Acura Integra, the 16-pin DLC diagnostic connector is located Under driver dash, right of steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Acura Integra with code P0204?
No. Cylinder 4 is disabled, causing rough running and unburned fuel delivery issues. Given that P0204 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.