MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.
P2004AcuraAcura TLX HubAll Acura P2004Medium Severity

P2004 on Acura TLX

Intake Manifold Runner Control (IMRC) Stuck Open (Bank 1)

Factory diagnostic protocol and troubleshooting wire for fault code P2004 specifically for the Acura TLX (2021–2026, 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD)).

Verified OEM Telemetry & Field Repair Tree
Acura TLX2021–2026
Acura TLX
Sedan2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD)
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
TLX SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. Repair Cost
$150 - $600 (DIY: $40 - $180)
Parts & Labor DIY
Check P2004 On Another Acura Model:
Diagnose P2004 on Specific TLX Model Year:

1. Symptoms of P2004 on Acura TLX

When the Engine Control Module (ECM/PCM) on your Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD)) logs fault code P2004, drivers commonly observe:

Check Engine Light on on Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD))
Sluggish low-RPM acceleration and low-end torque loss on Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD))
Engine runs fine at high highway RPMs (3,500+ RPM) on Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD))
Slightly rough idle or minor intake whistling noise on Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD))
Acura TLX OBD-II Port Location
The 16-pin diagnostic connector is located Driver footwell below steering column. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Acura TLX

Historical warranty claims and technical repair bulletins for Acura TLX point to the following failure distribution:

55%
Carbon buildup binding the intake manifold swirl flap runner plates (Acura OEM Part)
25%
Broken plastic IMRC actuator linkage rod or vacuum diaphragm (Acura OEM Part)
12%
Faulty electronic IMRC runner control motor / solenoid (Acura OEM Part)
8%
Cracked vacuum line to IMRC actuator (Acura OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Acura TLX.

3. Step-by-Step DIY Repair Guide for Acura TLX

01
Visually Inspect IMRC Actuator Linkage

Check the mechanical plastic linkage arms at the end of the intake manifold. Verify arms are not popped off or broken. on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).

Required Tool: Flashlight, Mirror
02
Test Runner Flap Movement Manually

Move the runner lever by hand. It should spring back smoothly without binding or gritty resistance. on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).

Required Tool: None
03
Test IMRC Solenoid / Actuator Motor

Command IMRC open and closed with bi-directional scan tool or check vacuum supply to diaphragm. on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).

Required Tool: OBD-II Bi-Directional Scanner or Vacuum Gauge
04
Clean Intake Manifold Carbon or Replace Actuator

Replace the broken linkage/actuator motor or remove manifold to clean heavy carbon deposits around the butterfly flaps. on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).

Required Tool: Socket Set, Carburetor Cleaner, Gasket Set
05
Clear DTCs and Verify Runner Operation

Clear trouble codes and confirm low-end acceleration is restored. on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Acura TLX (P2004)

Prime Fast Delivery & Verified Fitment
Direct-Fit Replacement Part

Acura TLX OEM Replacement Sensor

4.7 / 5.0 (Verified Fit)

Direct-fit replacement assembly engineered to OEM tolerances for Acura TLX.

$45 – $95 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Acura TLXVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Acura TLX

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Acura TLX:

4. Acura TLX P2004 FAQs

What causes code P2004 to trigger on a Acura TLX?

On the Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD)), P2004 is most frequently caused by Carbon buildup binding the intake manifold swirl flap runner plates or Broken plastic IMRC actuator linkage rod or vacuum diaphragm.

Where is the OBD-II port located on my Acura TLX?

On the Acura TLX, the 16-pin DLC diagnostic connector is located Driver footwell below steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Acura TLX with code P2004?

Yes. Low-end engine torque will feel sluggish, but vehicle is drivable. Given that P2004 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.