FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.
P0172AcuraAcura ZDX HubAll Acura P0172Medium Severity

P0172 on Acura ZDX: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0172 (System Too Rich (Bank 1) - Symptoms, Causes & Step-by-Step Fix) specifically on the Acura ZDX (2024–2026, Single / Dual Motor EV (340HP / Type S 500HP / SH-AWD)).

2024–2026
ZDXEV
Sensor Voltage Ref
0.1V – 5.0V Ref
ZDX SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0172 On Another Acura Model:

1. Symptoms of P0172 on Acura ZDX

When the Engine Control Module (ECM/PCM) on your Acura ZDX (Single / Dual Motor EV (340HP / Type S 500HP / SH-AWD)) logs fault code P0172, drivers commonly observe:

Check Engine Light on on Acura ZDX (Single / Dual Motor EV (340HP / Type S 500HP / SH-AWD))
Strong unburnt fuel odor from exhaust on Acura ZDX (Single / Dual Motor EV (340HP / Type S 500HP / SH-AWD))
Black carbon soot around exhaust tip on Acura ZDX (Single / Dual Motor EV (340HP / Type S 500HP / SH-AWD))
Rough idle and engine bogging under throttle on Acura ZDX (Single / Dual Motor EV (340HP / Type S 500HP / SH-AWD))
Noticeable drop in MPG on Acura ZDX (Single / Dual Motor EV (340HP / Type S 500HP / SH-AWD))
Acura ZDX OBD-II Port Location
The 16-pin diagnostic connector is located Driver lower dash bulkhead EV interface. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Acura ZDX

Historical warranty claims and technical repair bulletins for Acura ZDX point to the following failure distribution:

55%
Faulty or leaking fuel injector (Acura OEM Part)
25%
Contaminated Mass Air Flow (MAF) sensor (Acura OEM Part)
12%
Stuck closed EVAP canister purge valve (Acura OEM Part)
8%
Excessive fuel pressure regulator failure (Acura OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Acura ZDX.

3. Step-by-Step DIY Repair Guide for Acura ZDX

01
Clean MAF Sensor and Throttle Body

Use dedicated MAF cleaner to remove carbon buildup from sensor wires. on the Acura ZDX equipped with Single / Dual Motor EV (340HP / Type S 500HP / SH-AWD).

02
Check Short Term & Long Term Fuel Trims

Use live OBD-II scanner data; negative trims beyond -10% indicate the ECU is cutting fuel. on the Acura ZDX equipped with Single / Dual Motor EV (340HP / Type S 500HP / SH-AWD).

03
Inspect Fuel Injector Leak-Down

Perform a fuel pressure leak-down test to identify injectors leaking raw gasoline into cylinders while parked. on the Acura ZDX equipped with Single / Dual Motor EV (340HP / Type S 500HP / SH-AWD).

Other Common Fault Codes on Acura ZDX

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Acura ZDX:

4. Acura ZDX P0172 FAQs

What causes code P0172 to trigger on a Acura ZDX?

On the Acura ZDX (Single / Dual Motor EV (340HP / Type S 500HP / SH-AWD)), P0172 is most frequently caused by Faulty or leaking fuel injector or Contaminated Mass Air Flow (MAF) sensor.

Where is the OBD-II port located on my Acura ZDX?

On the Acura ZDX, the 16-pin DLC diagnostic connector is located Driver lower dash bulkhead EV interface. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Acura ZDX with code P0172?

Driveable short distances, but unburnt fuel can damage catalytic converters. Given that P0172 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.