P0155 on Audi A4
Factory diagnostic protocol and troubleshooting wire for fault code P0155 specifically for the Audi A4 (2020–2026, 2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP)).
1. Symptoms of P0155 on Audi A4
When the Engine Control Module (ECM/PCM) on your Audi A4 (2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP)) logs fault code P0155, drivers commonly observe:
2. Most Likely Causes on Audi A4
Historical warranty claims and technical repair bulletins for Audi A4 point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Audi A4
Inspect the O2 HTR fuse in the engine fuse box with a test light or multimeter. on the Audi A4 equipped with 2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP).
Unplug the sensor connector and measure resistance between the two heater pins. An open circuit (infinite ohms / OL) confirms a dead internal heater. on the Audi A4 equipped with 2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP).
Remove faulty sensor and install a new OEM oxygen sensor with built-in heater. on the Audi A4 equipped with 2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP).
Clear DTCs and allow engine to cool down, then restart to confirm P0155 does not return. on the Audi A4 equipped with 2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP).
Equipment for Diagnosing Audi A4 (P0155)
Audi A4 OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Audi A4.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Audi A4
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Audi A4:
4. Audi A4 P0155 FAQs
What causes code P0155 to trigger on a Audi A4?
On the Audi A4 (2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP)), P0155 is most frequently caused by Burnt-out heating element inside the Bank 2 Sensor 1 O2 sensor or Blown O2 heater fuse in under-hood fuse block.
Where is the OBD-II port located on my Audi A4?
On the Audi A4, the 16-pin DLC diagnostic connector is located Under driver side dashboard near hood release lever (pink/purple port). Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Audi A4 with code P0155?
Yes. The sensor will take longer to warm up, causing brief open-loop fuel delay on cold starts. Given that P0155 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.