P0116 on Audi Q5
Factory diagnostic protocol and troubleshooting wire for fault code P0116 specifically for the Audi Q5 (2020–2026, 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV).
1. Symptoms of P0116 on Audi Q5
When the Engine Control Module (ECM/PCM) on your Audi Q5 (2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV) logs fault code P0116, drivers commonly observe:
2. Most Likely Causes on Audi Q5
Historical warranty claims and technical repair bulletins for Audi Q5 point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Audi Q5
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0116 to note engine RPM, load, and voltage when the fault triggered. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Inspect the electrical connector and wiring harness related to P0116 for chafing, corrosion, moisture, or pin push-out. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Equipment for Diagnosing Audi Q5 (P0116)
VVT Oil Control Solenoid Valve
Restores accurate camshaft timing and oil pressure regulation on Audi Q5.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Audi Q5
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Audi Q5:
4. Audi Q5 P0116 FAQs
What causes code P0116 to trigger on a Audi Q5?
On the Audi Q5 (2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV), P0116 is most frequently caused by Stuck open thermostat or Air pocket in cooling system.
Where is the OBD-II port located on my Audi Q5?
On the Audi Q5, the 16-pin DLC diagnostic connector is located Left side under driver steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Audi Q5 with code P0116?
Caution. Verify engine is not overheating. Given that P0116 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.