P0117 on Audi Q5
Factory diagnostic protocol and troubleshooting wire for fault code P0117 specifically for the Audi Q5 (2020–2026, 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV).
1. Symptoms of P0117 on Audi Q5
When the Engine Control Module (ECM/PCM) on your Audi Q5 (2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV) logs fault code P0117, drivers commonly observe:
2. Most Likely Causes on Audi Q5
Historical warranty claims and technical repair bulletins for Audi Q5 point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Audi Q5
Read ECT live PID on scanner. If it reads 284°F (140°C) or higher with engine cold, a short to ground exists. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Unplug sensor connector while watching live data. If temperature drops to -40°F (-40°C), the sensor itself is shorted. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
If reading stays pegged at max with sensor unplugged, inspect harness for pinch points grounding against engine block. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Allow engine to cool, unscrew old ECT sensor from coolant crossover pipe or thermostat housing, install new OEM sensor with fresh thread sealant. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Bleed air from cooling system, clear DTCs, and verify normal temperature rise on live data. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Equipment for Diagnosing Audi Q5 (P0117)
VVT Oil Control Solenoid Valve
Restores accurate camshaft timing and oil pressure regulation on Audi Q5.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Audi Q5
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Audi Q5:
4. Audi Q5 P0117 FAQs
What causes code P0117 to trigger on a Audi Q5?
On the Audi Q5 (2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV), P0117 is most frequently caused by ECT sensor internal short to ground or Short circuit to ground in ECT signal wiring harness.
Where is the OBD-II port located on my Audi Q5?
On the Audi Q5, the 16-pin DLC diagnostic connector is located Left side under driver steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Audi Q5 with code P0117?
No. The ECU thinks the engine is at 280°F+ (overheating) and runs rich or disables cooling fan logic. Given that P0117 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.