P0298 on BMW i4
Factory diagnostic protocol and troubleshooting wire for fault code P0298 specifically for the BMW i4 (2022–2026, Single / Dual Motor EV (eDrive35, eDrive40, M50 536HP)).
1. Symptoms of P0298 on BMW i4
When the Engine Control Module (ECM/PCM) on your BMW i4 (Single / Dual Motor EV (eDrive35, eDrive40, M50 536HP)) logs fault code P0298, drivers commonly observe:
2. Most Likely Causes on BMW i4
Historical warranty claims and technical repair bulletins for BMW i4 point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for BMW i4
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0298 to note engine RPM, load, and voltage when the fault triggered. on the BMW i4 equipped with Single / Dual Motor EV (eDrive35, eDrive40, M50 536HP).
Inspect the electrical connector and wiring harness related to P0298 for chafing, corrosion, moisture, or pin push-out. on the BMW i4 equipped with Single / Dual Motor EV (eDrive35, eDrive40, M50 536HP).
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the BMW i4 equipped with Single / Dual Motor EV (eDrive35, eDrive40, M50 536HP).
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the BMW i4 equipped with Single / Dual Motor EV (eDrive35, eDrive40, M50 536HP).
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the BMW i4 equipped with Single / Dual Motor EV (eDrive35, eDrive40, M50 536HP).
Equipment for Diagnosing BMW i4 (P0298)
BMW i4 OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for BMW i4.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on BMW i4
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the BMW i4:
4. BMW i4 P0298 FAQs
What causes code P0298 to trigger on a BMW i4?
On the BMW i4 (Single / Dual Motor EV (eDrive35, eDrive40, M50 536HP)), P0298 is most frequently caused by Low engine oil level or Clogged oil cooler.
Where is the OBD-II port located on my BMW i4?
On the BMW i4, the 16-pin DLC diagnostic connector is located Under driver steering column OBD interface. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my BMW i4 with code P0298?
No. Pull over and let engine cool. Given that P0298 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.