P0137 on BMW M5
Factory diagnostic protocol and troubleshooting wire for fault code P0137 specifically for the BMW M5 (2020–2026, 4.4L Twin-Turbo V8 M HYBRID (717HP / 738 lb-ft torque)).
1. Symptoms of P0137 on BMW M5
When the Engine Control Module (ECM/PCM) on your BMW M5 (4.4L Twin-Turbo V8 M HYBRID (717HP / 738 lb-ft torque)) logs fault code P0137, drivers commonly observe:
2. Most Likely Causes on BMW M5
Historical warranty claims and technical repair bulletins for BMW M5 point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for BMW M5
Listen for exhaust ticking or black soot around flex pipe, flanges, and sensor bungs before the catalytic converter. on the BMW M5 equipped with 4.4L Twin-Turbo V8 M HYBRID (717HP / 738 lb-ft torque).
Monitor B1S2 voltage. Snap the throttle to enrich mixture; voltage should briefly spike above 0.8V. If it remains 0.0V–0.1V, sensor is defective or shorted. on the BMW M5 equipped with 4.4L Twin-Turbo V8 M HYBRID (717HP / 738 lb-ft torque).
Unplug harness, remove old sensor with 7/8 socket, install replacement sensor and plug firmly. on the BMW M5 equipped with 4.4L Twin-Turbo V8 M HYBRID (717HP / 738 lb-ft torque).
Clear DTCs and verify B1S2 holds steady between 0.45V and 0.75V during steady highway cruising. on the BMW M5 equipped with 4.4L Twin-Turbo V8 M HYBRID (717HP / 738 lb-ft torque).
Equipment for Diagnosing BMW M5 (P0137)
BMW M5 OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for BMW M5.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on BMW M5
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the BMW M5:
4. BMW M5 P0137 FAQs
What causes code P0137 to trigger on a BMW M5?
On the BMW M5 (4.4L Twin-Turbo V8 M HYBRID (717HP / 738 lb-ft torque)), P0137 is most frequently caused by Exhaust leak upstream of or directly at the Sensor 2 bung letting in fresh air or Faulty downstream oxygen sensor.
Where is the OBD-II port located on my BMW M5?
On the BMW M5, the 16-pin DLC diagnostic connector is located Driver lower footwell assembly. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my BMW M5 with code P0137?
Yes. Vehicle is fully drivable, but Check Engine Light will remain illuminated. Given that P0137 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.