Buick Enclave OBD-II Diagnostic Guide
Comprehensive diagnostic trouble code telemetry, sensor voltage thresholds, and step-by-step repair manuals for Buick Enclave models equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Top Check Engine Trouble Codes for Buick Enclave
P0420 on Buick Enclave: Diagnosis & Fix
Troubleshooting procedure for P0420: P0420: Catalyst System Efficiency Below Threshold (Bank 1) specifically affecting Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)).
P0300 on Buick Enclave: Diagnosis & Fix
Troubleshooting procedure for P0300: P0300: Random or Multiple Cylinder Misfire Detected specifically affecting Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)).
P0171 on Buick Enclave: Diagnosis & Fix
Troubleshooting procedure for P0171: P0171: System Too Lean (Bank 1) specifically affecting Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)).
P0128 on Buick Enclave: Diagnosis & Fix
Troubleshooting procedure for P0128: P0128: Coolant Temperature Below Thermostat Regulating Temperature specifically affecting Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)).
P0520 on Buick Enclave: Diagnosis & Fix
Troubleshooting procedure for P0520: P0520: Engine Oil Pressure Sensor/Switch Circuit Malfunction specifically affecting Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)).
All OBD-II Codes for Buick Enclave
P0300: Random or Multiple Cylinder Misfire Detected
P0420: Catalyst System Efficiency Below Threshold (Bank 1)
P0171: System Too Lean (Bank 1)
P0128: Coolant Temperature Below Thermostat Regulating Temperature
P0455: Evaporative Emission Control System Leak Detected (Gross Leak)
Mass Air Flow (MAF) Sensor Circuit Range/Performance
O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 1)
System Too Rich (Bank 1) - Symptoms, Causes & Step-by-Step Fix
EVAP System Small Leak Detected - Diagnosis & Repair Guide
Idle Control System RPM Higher Than Expected - Diagnosis
P0010: Camshaft Position Actuator Circuit / Open (Bank 1)
P0011: Camshaft Position - Timing Over-Advanced or System Performance (Bank 1)
P0012: Camshaft Position - Timing Over-Retarded (Bank 1)
P0013: Exhaust Camshaft Position Actuator Circuit / Open (Bank 1)
P0014: Exhaust Camshaft Position Timing Over-Advanced (Bank 1)
P0016: Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A)
P0017: Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor B)
P0100: Mass or Volume Air Flow Circuit Malfunction
Frequently Asked Questions
Where is the OBD-II diagnostic port located on the Buick Enclave?
On the Buick Enclave (2020–2026), the standard 16-pin DLC port is located: Driver lower knee bolster panel. It supports SAE J1979 / ISO 15765-4 CAN protocols for all handheld OBD-II code readers.
What are the most common Check Engine fault codes on the Buick Enclave?
The most frequently logged trouble codes on the Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)) include P0420, P0300, P0171, P0128.
How much does an OBD-II diagnostic scan cost for a Buick Enclave?
Most auto parts retailers (AutoZone, O'Reilly, Advance Auto) offer basic code reading free of charge. Dealership diagnostic scan fees average $120 to $180 based on Buick's standard $115/hr labor rate.
