MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0137 on Cadillac CT5-V Blackwing

O2 Sensor Circuit Low Voltage (Bank 1 Sensor 2)

Factory diagnostic protocol and troubleshooting wire for fault code P0137 specifically for the Cadillac CT5-V Blackwing (2022–2026, 6.2L Handbuilt Supercharged LT4 V8 (668HP / 659 lb-ft / 6-Speed Manual / 10-Speed Auto)).

Verified OEM Telemetry & Field Repair Tree
Cadillac CT5-V Blackwing2022–2026
Cadillac CT5-V Blackwing
Sedan6.2L Handbuilt Supercharged LT4 V8 (668HP / 659 lb-ft / 6-Speed Manual / 10-Speed Auto)
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
CT5-V Blackwing SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Drivable (Short Trip)
Low urgency level
Est. Repair Cost
$100 - $300 (DIY: $35 - $100)
Parts & Labor DIY
Check P0137 On Another Cadillac Model:
Diagnose P0137 on Specific CT5-V Blackwing Model Year:

1. Symptoms of P0137 on Cadillac CT5-V Blackwing

When the Engine Control Module (ECM/PCM) on your Cadillac CT5-V Blackwing (6.2L Handbuilt Supercharged LT4 V8 (668HP / 659 lb-ft / 6-Speed Manual / 10-Speed Auto)) logs fault code P0137, drivers commonly observe:

Check Engine Light on on Cadillac CT5-V Blackwing (6.2L Handbuilt Supercharged LT4 V8 (668HP / 659 lb-ft / 6-Speed Manual / 10-Speed Auto))
Downstream sensor voltage consistently below 0.15V on scan tool on Cadillac CT5-V Blackwing (6.2L Handbuilt Supercharged LT4 V8 (668HP / 659 lb-ft / 6-Speed Manual / 10-Speed Auto))
Failed emissions test on Cadillac CT5-V Blackwing (6.2L Handbuilt Supercharged LT4 V8 (668HP / 659 lb-ft / 6-Speed Manual / 10-Speed Auto))
Cadillac CT5-V Blackwing OBD-II Port Location
The 16-pin diagnostic connector is located Driver A-pillar base kick panel. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Cadillac CT5-V Blackwing

Historical warranty claims and technical repair bulletins for Cadillac CT5-V Blackwing point to the following failure distribution:

55%
Exhaust leak upstream of or directly at the Sensor 2 bung letting in fresh air (Cadillac OEM Part)
25%
Faulty downstream oxygen sensor (Cadillac OEM Part)
12%
Short to ground in sensor signal wire (Cadillac OEM Part)
8%
Extremely lean exhaust condition (Cadillac OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Cadillac CT5-V Blackwing.

3. Step-by-Step DIY Repair Guide for Cadillac CT5-V Blackwing

01
Inspect Exhaust System for Leaks

Listen for exhaust ticking or black soot around flex pipe, flanges, and sensor bungs before the catalytic converter. on the Cadillac CT5-V Blackwing equipped with 6.2L Handbuilt Supercharged LT4 V8 (668HP / 659 lb-ft / 6-Speed Manual / 10-Speed Auto).

Required Tool: Flashlight, Jack Stands
02
Check Sensor Signal Voltage with Scan Tool

Monitor B1S2 voltage. Snap the throttle to enrich mixture; voltage should briefly spike above 0.8V. If it remains 0.0V–0.1V, sensor is defective or shorted. on the Cadillac CT5-V Blackwing equipped with 6.2L Handbuilt Supercharged LT4 V8 (668HP / 659 lb-ft / 6-Speed Manual / 10-Speed Auto).

Required Tool: OBD-II Scanner
03
Replace Downstream O2 Sensor

Unplug harness, remove old sensor with 7/8 socket, install replacement sensor and plug firmly. on the Cadillac CT5-V Blackwing equipped with 6.2L Handbuilt Supercharged LT4 V8 (668HP / 659 lb-ft / 6-Speed Manual / 10-Speed Auto).

Required Tool: O2 Sensor Socket, Ratchet
04
Clear Codes

Clear DTCs and verify B1S2 holds steady between 0.45V and 0.75V during steady highway cruising. on the Cadillac CT5-V Blackwing equipped with 6.2L Handbuilt Supercharged LT4 V8 (668HP / 659 lb-ft / 6-Speed Manual / 10-Speed Auto).

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Cadillac CT5-V Blackwing (P0137)

Prime Fast Delivery & Verified Fitment
Direct-Fit Replacement Part

Cadillac CT5-V Blackwing OEM Replacement Sensor

4.7 / 5.0 (Verified Fit)

Direct-fit replacement assembly engineered to OEM tolerances for Cadillac CT5-V Blackwing.

$45 – $95 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Cadillac CT5-V BlackwingVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Cadillac CT5-V Blackwing

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Cadillac CT5-V Blackwing:

4. Cadillac CT5-V Blackwing P0137 FAQs

What causes code P0137 to trigger on a Cadillac CT5-V Blackwing?

On the Cadillac CT5-V Blackwing (6.2L Handbuilt Supercharged LT4 V8 (668HP / 659 lb-ft / 6-Speed Manual / 10-Speed Auto)), P0137 is most frequently caused by Exhaust leak upstream of or directly at the Sensor 2 bung letting in fresh air or Faulty downstream oxygen sensor.

Where is the OBD-II port located on my Cadillac CT5-V Blackwing?

On the Cadillac CT5-V Blackwing, the 16-pin DLC diagnostic connector is located Driver A-pillar base kick panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Cadillac CT5-V Blackwing with code P0137?

Yes. Vehicle is fully drivable, but Check Engine Light will remain illuminated. Given that P0137 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.