MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0155 on Cadillac Lyriq

O2 Sensor Heater Circuit Malfunction (Bank 2 Sensor 1)

Factory diagnostic protocol and troubleshooting wire for fault code P0155 specifically for the Cadillac Lyriq (2023–2026, Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP)).

Verified OEM Telemetry & Field Repair Tree
Cadillac Lyriq2023–2026
Cadillac Lyriq
EVUltium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP)
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
Lyriq SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. Repair Cost
$120 - $350 (DIY: $45 - $120)
Parts & Labor DIY
Check P0155 On Another Cadillac Model:
Diagnose P0155 on Specific Lyriq Model Year:

1. Symptoms of P0155 on Cadillac Lyriq

When the Engine Control Module (ECM/PCM) on your Cadillac Lyriq (Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP)) logs fault code P0155, drivers commonly observe:

Check Engine Light on immediately after cold start on Cadillac Lyriq (Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP))
Slightly increased cold-start emissions on Cadillac Lyriq (Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP))
No major driving performance issues once engine reaches full operating temperature on Cadillac Lyriq (Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP))
Cadillac Lyriq OBD-II Port Location
The 16-pin diagnostic connector is located Under driver steering column beneath knee bolster. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Cadillac Lyriq

Historical warranty claims and technical repair bulletins for Cadillac Lyriq point to the following failure distribution:

55%
Burnt-out heating element inside the Bank 2 Sensor 1 O2 sensor (Cadillac OEM Part)
25%
Blown O2 heater fuse in under-hood fuse block (Cadillac OEM Part)
12%
Corroded or broken heater power/ground wiring (Cadillac OEM Part)
8%
Faulty heater driver circuit in the PCM (Cadillac OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Cadillac Lyriq.

3. Step-by-Step DIY Repair Guide for Cadillac Lyriq

01
Check O2 Heater Fuse

Inspect the O2 HTR fuse in the engine fuse box with a test light or multimeter. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).

Required Tool: Fuse Puller, Test Light
02
Test Heater Resistance on Bank 2 Sensor 1

Unplug the sensor connector and measure resistance between the two heater pins. An open circuit (infinite ohms / OL) confirms a dead internal heater. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).

Required Tool: Digital Multimeter
03
Replace Bank 2 Upstream O2 Sensor

Remove faulty sensor and install a new OEM oxygen sensor with built-in heater. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).

Required Tool: 22mm O2 Sensor Socket, Ratchet
04
Clear Codes and Perform Cold Start Verification

Clear DTCs and allow engine to cool down, then restart to confirm P0155 does not return. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Cadillac Lyriq (P0155)

Prime Fast Delivery & Verified Fitment
Direct-Fit Replacement Part

Cadillac Lyriq OEM Replacement Sensor

4.7 / 5.0 (Verified Fit)

Direct-fit replacement assembly engineered to OEM tolerances for Cadillac Lyriq.

$45 – $95 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Cadillac LyriqVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Cadillac Lyriq

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Cadillac Lyriq:

4. Cadillac Lyriq P0155 FAQs

What causes code P0155 to trigger on a Cadillac Lyriq?

On the Cadillac Lyriq (Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP)), P0155 is most frequently caused by Burnt-out heating element inside the Bank 2 Sensor 1 O2 sensor or Blown O2 heater fuse in under-hood fuse block.

Where is the OBD-II port located on my Cadillac Lyriq?

On the Cadillac Lyriq, the 16-pin DLC diagnostic connector is located Under driver steering column beneath knee bolster. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Cadillac Lyriq with code P0155?

Yes. The sensor will take longer to warm up, causing brief open-loop fuel delay on cold starts. Given that P0155 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.