MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0351 on Chevrolet Corvette

Ignition Coil A Primary/Secondary Circuit Malfunction

Factory diagnostic protocol and troubleshooting wire for fault code P0351 specifically for the Chevrolet Corvette (2020–2026, 6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid).

Verified OEM Telemetry & Field Repair Tree
Chevrolet Corvette2020–2026
Chevrolet Corvette
Coupe6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
Corvette SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Not Recommended
Critical urgency level
Est. Repair Cost
$100 - $350 (DIY: $30 - $90)
Parts & Labor DIY
Check P0351 On Another Chevrolet Model:
Diagnose P0351 on Specific Corvette Model Year:

1. Symptoms of P0351 on Chevrolet Corvette

When the Engine Control Module (ECM/PCM) on your Chevrolet Corvette (6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid) logs fault code P0351, drivers commonly observe:

Flashing Check Engine Light on Chevrolet Corvette (6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid)
Severe engine shuddering and jerking under acceleration on Chevrolet Corvette (6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid)
Hard misfire on Cylinder 1 (accompanied by P0301) on Chevrolet Corvette (6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid)
Strong smell of unburned gasoline from exhaust on Chevrolet Corvette (6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid)
Chevrolet Corvette OBD-II Port Location
The 16-pin diagnostic connector is located Driver footwell lower panel. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Chevrolet Corvette

Historical warranty claims and technical repair bulletins for Chevrolet Corvette point to the following failure distribution:

55%
Failed ignition coil pack on Cylinder 1 (Coil A) (Chevrolet OEM Part)
25%
Broken or melted wiring harness to ignition coil 1 (Chevrolet OEM Part)
12%
Corroded or broken terminal pins in coil electrical connector (Chevrolet OEM Part)
8%
Burned ignition driver transistor (IGBT) inside the ECM/PCM (Chevrolet OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Chevrolet Corvette.

3. Step-by-Step DIY Repair Guide for Chevrolet Corvette

01
Locate Coil A (Cylinder 1 Ignition Coil)

Identify Cylinder 1 ignition coil pack mounted on the valve cover. on the Chevrolet Corvette equipped with 6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid.

Required Tool: Flashlight
02
Perform Coil Swap Test

Swap Coil 1 with Coil 2. Clear codes and restart engine. If code switches to P0352 (Coil B), the ignition coil is 100% defective. on the Chevrolet Corvette equipped with 6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid.

Required Tool: 10mm Socket, Ratchet, OBD-II Scanner
03
Test Wiring Harness if Code Remains P0351

Check for 12V battery power, chassis ground, and 5V trigger pulse from the PCM on the 3-pin / 4-pin harness plug. on the Chevrolet Corvette equipped with 6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid.

Required Tool: Digital Multimeter, Test Light
04
Replace Ignition Coil & Spark Plug

Install a new OEM ignition coil (e.g. Denso, Motorcraft, Delphi) and replace the spark plug on Cylinder 1. on the Chevrolet Corvette equipped with 6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid.

Required Tool: 5/8 Spark Plug Socket, 10mm Socket, Ratchet
05
Clear Trouble Codes and Road Test

Clear DTCs and verify smooth acceleration under load. on the Chevrolet Corvette equipped with 6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid.

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Chevrolet Corvette (P0351)

Prime Fast Delivery & Verified Fitment
OEM Ignition Component

Direct-Fit Laser Iridium Spark Plugs (Set of 4/6)

4.8 / 5.0 (Top Rated)

Pre-gapped iridium spark plugs engineered to restore smooth combustion on Chevrolet Corvette.

$36 – $68 Prime
Check Price on Amazon
Ignition Service Tool

Magnetic Swivel Spark Plug Socket Set

4.8 / 5.0 (Amazon Choice)

360-degree magnetic swivel socket prevents ceramic plug cracks inside deep engine spark wells.

$16.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Chevrolet CorvetteVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Chevrolet Corvette

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Chevrolet Corvette:

4. Chevrolet Corvette P0351 FAQs

What causes code P0351 to trigger on a Chevrolet Corvette?

On the Chevrolet Corvette (6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid), P0351 is most frequently caused by Failed ignition coil pack on Cylinder 1 (Coil A) or Broken or melted wiring harness to ignition coil 1.

Where is the OBD-II port located on my Chevrolet Corvette?

On the Chevrolet Corvette, the 16-pin DLC diagnostic connector is located Driver footwell lower panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Chevrolet Corvette with code P0351?

No. Cylinder 1 ignition coil has failed completely, causing an active misfire and dumping unburned fuel into the catalytic converter. Given that P0351 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.