U0104 on Chevrolet Tahoe
Factory diagnostic protocol and troubleshooting wire for fault code U0104 specifically for the Chevrolet Tahoe (2021–2026, 5.3L / 6.2L V8 & 3.0L Duramax Diesel).
1. Symptoms of U0104 on Chevrolet Tahoe
When the Engine Control Module (ECM/PCM) on your Chevrolet Tahoe (5.3L / 6.2L V8 & 3.0L Duramax Diesel) logs fault code U0104, drivers commonly observe:
2. Most Likely Causes on Chevrolet Tahoe
Historical warranty claims and technical repair bulletins for Chevrolet Tahoe point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Chevrolet Tahoe
Clean snow, ice, mud, or dead bugs off front radar emblem. on the Chevrolet Tahoe equipped with 5.3L / 6.2L V8 & 3.0L Duramax Diesel.
Verify power feed to radar sensor. on the Chevrolet Tahoe equipped with 5.3L / 6.2L V8 & 3.0L Duramax Diesel.
Execute optical/radar alignment procedure if bumper was removed. on the Chevrolet Tahoe equipped with 5.3L / 6.2L V8 & 3.0L Duramax Diesel.
Clear DTCs and test cruise on highway. on the Chevrolet Tahoe equipped with 5.3L / 6.2L V8 & 3.0L Duramax Diesel.
Equipment for Diagnosing Chevrolet Tahoe (U0104)
Chevrolet Tahoe OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Chevrolet Tahoe.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Chevrolet Tahoe
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Chevrolet Tahoe:
4. Chevrolet Tahoe U0104 FAQs
What causes code U0104 to trigger on a Chevrolet Tahoe?
On the Chevrolet Tahoe (5.3L / 6.2L V8 & 3.0L Duramax Diesel), U0104 is most frequently caused by Blocked or dirty front radar sensor in grille/bumper or Blown radar module fuse.
Where is the OBD-II port located on my Chevrolet Tahoe?
On the Chevrolet Tahoe, the 16-pin DLC diagnostic connector is located Under driver side steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Chevrolet Tahoe with code U0104?
Yes. Normal driving is unaffected, but Adaptive Cruise Control will not engage. Given that U0104 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.