P0202 on Chrysler Voyager
Factory diagnostic protocol and troubleshooting wire for fault code P0202 specifically for the Chrysler Voyager (2020–2026, 3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic)).
1. Symptoms of P0202 on Chrysler Voyager
When the Engine Control Module (ECM/PCM) on your Chrysler Voyager (3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic)) logs fault code P0202, drivers commonly observe:
2. Most Likely Causes on Chrysler Voyager
Historical warranty claims and technical repair bulletins for Chrysler Voyager point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Chrysler Voyager
Measure resistance across injector 2 terminals. Compare to Cylinder 1 and 3 (spec: 12–16 ohms). on the Chrysler Voyager equipped with 3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic).
Check for 12V on power wire and verify ground pulsing using a noid light while cranking. on the Chrysler Voyager equipped with 3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic).
Depressurize fuel system, lift rail, swap injector, lube new O-rings, and reinstall rail. on the Chrysler Voyager equipped with 3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic).
Clear DTC memory and monitor misfire counters on live data. on the Chrysler Voyager equipped with 3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic).
Equipment for Diagnosing Chrysler Voyager (P0202)
Chrysler Voyager OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Chrysler Voyager.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Chrysler Voyager
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Chrysler Voyager:
4. Chrysler Voyager P0202 FAQs
What causes code P0202 to trigger on a Chrysler Voyager?
On the Chrysler Voyager (3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic)), P0202 is most frequently caused by Cylinder 2 fuel injector internal coil failure or Broken wiring or corroded connector pin on Cylinder 2 harness.
Where is the OBD-II port located on my Chrysler Voyager?
On the Chrysler Voyager, the 16-pin DLC diagnostic connector is located Driver lower kick panel near hood release lever. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Chrysler Voyager with code P0202?
No. Cylinder 2 is completely disabled by an electrical circuit fault, causing hard misfires. Given that P0202 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.