P0741 on 2016 Dodge Challenger
Technical troubleshooting wire for fault code P0741 specifically tailored for the 2016 Dodge Challenger. Includes wiring sensor pinouts, freeze frame PID parameters, and step-by-step diagnostic tree.
Common 2016 Challenger Symptoms
- Check Engine Light illuminated
- Engine RPM is 200–400 RPM higher than normal at 65–75 mph highway speeds
- Transmission fluid runs hotter than normal
- Failed emissions test due to incomplete continuous monitor
Likely Root Causes on 2016 Challenger
- Faulty TCC lockup solenoid or valve body channel stuck with varnish
- Burnt or contaminated automatic transmission fluid
- Worn torque converter clutch internal friction lining
- Low transmission line pressure or leaking input shaft seal
Step-by-Step Fix Protocol for 2016 Dodge Challenger
Connect an OBD-II scanner to the DLC port under the driver dashboard. Record engine RPM, Short Term / Long Term Fuel Trim (STFT/LTFT), and engine coolant temperature at the moment P0741 set.
Inspect the sensor connector on the 2016 Challenger engine bay. Use a multimeter to verify reference voltage (5.0V / 12.0V) and ground continuity.
Replace the verified defective component using OEM or equivalent grade parts. Clear DTC P0741 and complete an EPA drive cycle to verify readiness monitors set to READY.
Equipment for Diagnosing 2016 Dodge Challenger (P0741)
2016 Dodge Challenger OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for 2016 Dodge Challenger.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.