U0102 on 2025 Dodge Charger
Technical troubleshooting wire for fault code U0102 specifically tailored for the 2025 Dodge Charger. Includes wiring sensor pinouts, freeze frame PID parameters, and step-by-step diagnostic tree.
Common 2025 Charger Symptoms
- 'Service 4WD' or '4WD System Error' message on dash
- 4WD selector switch unresponsive (lights out on switch)
- Vehicle stuck in 2WD or last selected 4WD mode
Likely Root Causes on 2025 Charger
- Corroded TCCM power/ground wiring under vehicle
- Blown 4WD / TCCM fuse in engine fuse panel
- Faulty Transfer Case Control Module
- Faulty transfer case shift encoder motor
Step-by-Step Fix Protocol for 2025 Dodge Charger
Connect an OBD-II scanner to the DLC port under the driver dashboard. Record engine RPM, Short Term / Long Term Fuel Trim (STFT/LTFT), and engine coolant temperature at the moment U0102 set.
Inspect the sensor connector on the 2025 Charger engine bay. Use a multimeter to verify reference voltage (5.0V / 12.0V) and ground continuity.
Replace the verified defective component using OEM or equivalent grade parts. Clear DTC U0102 and complete an EPA drive cycle to verify readiness monitors set to READY.
Equipment for Diagnosing 2025 Dodge Charger (U0102)
2025 Dodge Charger OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for 2025 Dodge Charger.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.