P0116 on Ford Maverick
Factory diagnostic protocol and troubleshooting wire for fault code P0116 specifically for the Ford Maverick (2022–2026, 2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP)).
1. Symptoms of P0116 on Ford Maverick
When the Engine Control Module (ECM/PCM) on your Ford Maverick (2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP)) logs fault code P0116, drivers commonly observe:
2. Most Likely Causes on Ford Maverick
Historical warranty claims and technical repair bulletins for Ford Maverick point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Ford Maverick
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0116 to note engine RPM, load, and voltage when the fault triggered. on the Ford Maverick equipped with 2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP).
Inspect the electrical connector and wiring harness related to P0116 for chafing, corrosion, moisture, or pin push-out. on the Ford Maverick equipped with 2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP).
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the Ford Maverick equipped with 2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP).
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the Ford Maverick equipped with 2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP).
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the Ford Maverick equipped with 2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP).
Equipment for Diagnosing Ford Maverick (P0116)
VVT Oil Control Solenoid Valve
Restores accurate camshaft timing and oil pressure regulation on Ford Maverick.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Ford Maverick
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Ford Maverick:
4. Ford Maverick P0116 FAQs
What causes code P0116 to trigger on a Ford Maverick?
On the Ford Maverick (2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP)), P0116 is most frequently caused by Stuck open thermostat or Air pocket in cooling system.
Where is the OBD-II port located on my Ford Maverick?
On the Ford Maverick, the 16-pin DLC diagnostic connector is located Under driver side steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Ford Maverick with code P0116?
Caution. Verify engine is not overheating. Given that P0116 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.