C0242 on GMC Yukon
Factory diagnostic protocol and troubleshooting wire for fault code C0242 specifically for the GMC Yukon (2021–2026, 5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax).
1. Symptoms of C0242 on GMC Yukon
When the Engine Control Module (ECM/PCM) on your GMC Yukon (5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax) logs fault code C0242, drivers commonly observe:
2. Most Likely Causes on GMC Yukon
Historical warranty claims and technical repair bulletins for GMC Yukon point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for GMC Yukon
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code C0242 to note engine RPM, load, and voltage when the fault triggered. on the GMC Yukon equipped with 5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax.
Inspect the electrical connector and wiring harness related to C0242 for chafing, corrosion, moisture, or pin push-out. on the GMC Yukon equipped with 5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax.
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the GMC Yukon equipped with 5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax.
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the GMC Yukon equipped with 5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax.
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the GMC Yukon equipped with 5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax.
Equipment for Diagnosing GMC Yukon (C0242)
GMC Yukon OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for GMC Yukon.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on GMC Yukon
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the GMC Yukon:
4. GMC Yukon C0242 FAQs
What causes code C0242 to trigger on a GMC Yukon?
On the GMC Yukon (5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax), C0242 is most frequently caused by Engine misfire or throttle code present in ECM or Traction control actively engaging.
Where is the OBD-II port located on my GMC Yukon?
On the GMC Yukon, the 16-pin DLC diagnostic connector is located Driver side under steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my GMC Yukon with code C0242?
Yes. Traction control active or secondary engine fault. Given that C0242 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.