P0507 on Honda HR-V: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0507 (Idle Control System RPM Higher Than Expected - Diagnosis) specifically on the Honda HR-V (2023–2026, 2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD)).
1. Symptoms of P0507 on Honda HR-V
When the Engine Control Module (ECM/PCM) on your Honda HR-V (2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD)) logs fault code P0507, drivers commonly observe:
2. Most Likely Causes on Honda HR-V
Historical warranty claims and technical repair bulletins for Honda HR-V point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Honda HR-V
Spray brake cleaner around intake manifold gaskets; an RPM change reveals the leak location. on the Honda HR-V equipped with 2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD).
Gently clean carbon soot around throttle blade using throttle cleaner and microfiber towel. on the Honda HR-V equipped with 2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD).
Follow vehicle-specific ignition key on/off timing sequence or use OBD scanner to reset baseline idle. on the Honda HR-V equipped with 2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD).
Other Common Fault Codes on Honda HR-V
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Honda HR-V:
4. Honda HR-V P0507 FAQs
What causes code P0507 to trigger on a Honda HR-V?
On the Honda HR-V (2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD)), P0507 is most frequently caused by Intake manifold vacuum leak or Carbon buildup causing sticky electronic throttle body.
Where is the OBD-II port located on my Honda HR-V?
On the Honda HR-V, the 16-pin DLC diagnostic connector is located Driver footwell lower trim near kick panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Honda HR-V with code P0507?
Driveable, but braking distance may increase slightly due to high engine idle. Given that P0507 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.