FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.
P0420HondaHonda Pilot HubAll Honda P0420Medium Severity

P0420 on Honda Pilot: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0420 (P0420: Catalyst System Efficiency Below Threshold (Bank 1)) specifically on the Honda Pilot (2021–2026, 3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto)).

Honda Pilot
DIY Parts Estimate
$400 - $1,800 (DIY: $150 - $400)
Pilot OEM Fitment
Shop Labor Quote
$180 – $380
Based on $115/hr labor
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0420 On Another Honda Model:
Honda CivicHonda AccordHonda CR-VHonda Pilot

1. Symptoms of P0420 on Honda Pilot

When the Engine Control Module (ECM/PCM) on your Honda Pilot (3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto)) logs fault code P0420, drivers commonly observe:

Illuminated Check Engine Light (steady) on Honda Pilot (3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto))
Rotten egg / sulfur odor from exhaust on Honda Pilot (3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto))
Slight decrease in fuel efficiency and sluggish highway passing power on Honda Pilot (3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto))
Vehicle fails state OBD-II emissions smog test on Honda Pilot (3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto))
Honda Pilot OBD-II Port Location
The 16-pin diagnostic connector is located Under driver steering column. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Honda Pilot

Historical warranty claims and technical repair bulletins for Honda Pilot point to the following failure distribution:

55%
Catalytic converter internal substrate degraded or melted (Honda OEM Part)
25%
Faulty Downstream Oxygen Sensor (O2 Sensor Bank 1 Sensor 2) (Honda OEM Part)
12%
Exhaust leak upstream of the catalytic converter (Honda OEM Part)
8%
Engine burning oil or coolant contaminating the catalyst (Honda OEM Part)

3. Step-by-Step DIY Repair Guide for Honda Pilot

01
Check Live O2 Sensor Voltage Data

Use a live-data scan tool. Downstream O2 sensor should show a steady voltage around 0.45V to 0.7V. If it fluctuates rapidly between 0.1V and 0.9V like the upstream sensor, the cat is not storing oxygen. on the Honda Pilot equipped with 3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto).

Required Tool: OBD-II Live Scanner
02
Inspect Exhaust Pipes for Upstream Leaks

Check exhaust manifold gaskets and flex pipes before the catalytic converter. Extra air entering exhaust false-triggers the P0420 code. on the Honda Pilot equipped with 3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto).

Required Tool: Jack stands, Flashlight, Soapy water spray
03
Test and Replace Downstream O2 Sensor

If the sensor is sluggish or older than 100,000 miles, replace the downstream oxygen sensor first before condemning the expensive catalytic converter. on the Honda Pilot equipped with 3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto).

Required Tool: 22mm O2 Sensor Socket, Penetrating oil
04
Try Catalytic Converter Cleaner Solution

Pour a designated catalytic cleaner (e.g. Cataclean) into 1/4 tank of fuel and drive 50 miles on the highway to burn off surface carbon deposits. on the Honda Pilot equipped with 3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto).

Required Tool: Cataclean fuel treatment
05
Replace Catalytic Converter Assembly

If codes return after sensor replacement and cleaning, replace the catalytic converter with an EPA or CARB compliant unit. on the Honda Pilot equipped with 3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto).

Required Tool: Wrench set, New gaskets, Torque wrench

Other Common Fault Codes on Honda Pilot

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Honda Pilot:

4. Honda Pilot P0420 FAQs

What causes code P0420 to trigger on a Honda Pilot?

On the Honda Pilot (3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto)), P0420 is most frequently caused by Catalytic converter internal substrate degraded or melted or Faulty Downstream Oxygen Sensor (O2 Sensor Bank 1 Sensor 2).

Where is the OBD-II port located on my Honda Pilot?

On the Honda Pilot, the 16-pin DLC diagnostic connector is located Under driver steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Honda Pilot with code P0420?

Yes for moderate distances, but vehicle will fail state emissions inspections. Given that P0420 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.