P0352 on Hyundai Ioniq 5
Factory diagnostic protocol and troubleshooting wire for fault code P0352 specifically for the Hyundai Ioniq 5 (2022–2026, Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP)).
1. Symptoms of P0352 on Hyundai Ioniq 5
When the Engine Control Module (ECM/PCM) on your Hyundai Ioniq 5 (Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP)) logs fault code P0352, drivers commonly observe:
2. Most Likely Causes on Hyundai Ioniq 5
Historical warranty claims and technical repair bulletins for Hyundai Ioniq 5 point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Hyundai Ioniq 5
Swap Coil 2 with Coil 1. If code becomes P0351, replace coil. on the Hyundai Ioniq 5 equipped with Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP).
Verify 12V power and trigger pulse. on the Hyundai Ioniq 5 equipped with Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP).
Replace Coil B with OEM part. on the Hyundai Ioniq 5 equipped with Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP).
Clear DTCs and confirm zero misfires. on the Hyundai Ioniq 5 equipped with Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP).
Equipment for Diagnosing Hyundai Ioniq 5 (P0352)
Direct-Fit Laser Iridium Spark Plugs (Set of 4/6)
Pre-gapped iridium spark plugs engineered to restore smooth combustion on Hyundai Ioniq 5.
Magnetic Swivel Spark Plug Socket Set
360-degree magnetic swivel socket prevents ceramic plug cracks inside deep engine spark wells.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Hyundai Ioniq 5
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Hyundai Ioniq 5:
4. Hyundai Ioniq 5 P0352 FAQs
What causes code P0352 to trigger on a Hyundai Ioniq 5?
On the Hyundai Ioniq 5 (Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP)), P0352 is most frequently caused by Dead Cylinder 2 ignition coil or Damaged harness wiring.
Where is the OBD-II port located on my Hyundai Ioniq 5?
On the Hyundai Ioniq 5, the 16-pin DLC diagnostic connector is located Driver side lower dash bezel near steering base. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Hyundai Ioniq 5 with code P0352?
No. Cylinder 2 ignition coil has failed. Given that P0352 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.