P0230 on Jeep Compass
Factory diagnostic protocol and troubleshooting wire for fault code P0230 specifically for the Jeep Compass (2021–2026, 2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP)).
1. Symptoms of P0230 on Jeep Compass
When the Engine Control Module (ECM/PCM) on your Jeep Compass (2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP)) logs fault code P0230, drivers commonly observe:
2. Most Likely Causes on Jeep Compass
Historical warranty claims and technical repair bulletins for Jeep Compass point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Jeep Compass
Inspect the Fuel Pump fuse in under-hood fuse box. Swap the fuel pump relay with an identical non-critical relay (like the horn relay). on the Jeep Compass equipped with 2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP).
Have an assistant turn key to ON while listening at the open fuel filler neck. A healthy pump hums for 2–3 seconds. on the Jeep Compass equipped with 2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP).
Check for 12V battery power on pin 30 and 86, and check for PCM ground command on pin 85 when key is turned on. on the Jeep Compass equipped with 2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP).
On vehicles with an electronic FPDM (such as Ford F-150s mounted on rear axle), check for corrosion or cracked aluminum housing. on the Jeep Compass equipped with 2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP).
If power and ground reach the pump connector but pump does not spin, drop tank or access fuel pump hatch to replace pump assembly. on the Jeep Compass equipped with 2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP).
Equipment for Diagnosing Jeep Compass (P0230)
Jeep Compass OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Jeep Compass.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Jeep Compass
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Jeep Compass:
4. Jeep Compass P0230 FAQs
What causes code P0230 to trigger on a Jeep Compass?
On the Jeep Compass (2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP)), P0230 is most frequently caused by Blown fuel pump fuse or burnt fuel pump relay or Open or shorted control circuit wiring between PCM and fuel pump relay.
Where is the OBD-II port located on my Jeep Compass?
On the Jeep Compass, the 16-pin DLC diagnostic connector is located Driver lower dash near hood lever assembly. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Jeep Compass with code P0230?
No. The engine will crank but not start or will suddenly stall while driving when the fuel pump cuts out. Given that P0230 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.