P0354 on Jeep Grand Cherokee
Factory diagnostic protocol and troubleshooting wire for fault code P0354 specifically for the Jeep Grand Cherokee (2021–2026, 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP)).
1. Symptoms of P0354 on Jeep Grand Cherokee
When the Engine Control Module (ECM/PCM) on your Jeep Grand Cherokee (3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP)) logs fault code P0354, drivers commonly observe:
2. Most Likely Causes on Jeep Grand Cherokee
Historical warranty claims and technical repair bulletins for Jeep Grand Cherokee point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Jeep Grand Cherokee
Swap Coil 4 to Cylinder 1. on the Jeep Grand Cherokee equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP).
Install new OEM coil pack. on the Jeep Grand Cherokee equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP).
Clear memory and road test. on the Jeep Grand Cherokee equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP).
Equipment for Diagnosing Jeep Grand Cherokee (P0354)
Direct-Fit Laser Iridium Spark Plugs (Set of 4/6)
Pre-gapped iridium spark plugs engineered to restore smooth combustion on Jeep Grand Cherokee.
Magnetic Swivel Spark Plug Socket Set
360-degree magnetic swivel socket prevents ceramic plug cracks inside deep engine spark wells.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Jeep Grand Cherokee
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Jeep Grand Cherokee:
4. Jeep Grand Cherokee P0354 FAQs
What causes code P0354 to trigger on a Jeep Grand Cherokee?
On the Jeep Grand Cherokee (3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP)), P0354 is most frequently caused by Dead Cylinder 4 ignition coil or Wiring damage.
Where is the OBD-II port located on my Jeep Grand Cherokee?
On the Jeep Grand Cherokee, the 16-pin DLC diagnostic connector is located Under driver side dashboard above foot pedals. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Jeep Grand Cherokee with code P0354?
No. Cylinder 4 ignition coil has failed. Given that P0354 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.