P0355 on Jeep Grand Cherokee
Factory diagnostic protocol and troubleshooting wire for fault code P0355 specifically for the Jeep Grand Cherokee (2021–2026, 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP)).
1. Symptoms of P0355 on Jeep Grand Cherokee
When the Engine Control Module (ECM/PCM) on your Jeep Grand Cherokee (3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP)) logs fault code P0355, drivers commonly observe:
2. Most Likely Causes on Jeep Grand Cherokee
Historical warranty claims and technical repair bulletins for Jeep Grand Cherokee point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Jeep Grand Cherokee
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0355 to note engine RPM, load, and voltage when the fault triggered. on the Jeep Grand Cherokee equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP).
Inspect the electrical connector and wiring harness related to P0355 for chafing, corrosion, moisture, or pin push-out. on the Jeep Grand Cherokee equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP).
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the Jeep Grand Cherokee equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP).
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the Jeep Grand Cherokee equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP).
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the Jeep Grand Cherokee equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP).
Equipment for Diagnosing Jeep Grand Cherokee (P0355)
Direct-Fit Laser Iridium Spark Plugs (Set of 4/6)
Pre-gapped iridium spark plugs engineered to restore smooth combustion on Jeep Grand Cherokee.
Magnetic Swivel Spark Plug Socket Set
360-degree magnetic swivel socket prevents ceramic plug cracks inside deep engine spark wells.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Jeep Grand Cherokee
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Jeep Grand Cherokee:
4. Jeep Grand Cherokee P0355 FAQs
What causes code P0355 to trigger on a Jeep Grand Cherokee?
On the Jeep Grand Cherokee (3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP)), P0355 is most frequently caused by Dead Cylinder 5 ignition coil or Wiring damage.
Where is the OBD-II port located on my Jeep Grand Cherokee?
On the Jeep Grand Cherokee, the 16-pin DLC diagnostic connector is located Under driver side dashboard above foot pedals. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Jeep Grand Cherokee with code P0355?
No. Cylinder 5 ignition coil dead. Given that P0355 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.