P0117 on Kia EV6
Factory diagnostic protocol and troubleshooting wire for fault code P0117 specifically for the Kia EV6 (2022–2026, Single RWD (229HP) / Dual AWD (320HP) / GT 577HP / 77.4 kWh battery).
1. Symptoms of P0117 on Kia EV6
When the Engine Control Module (ECM/PCM) on your Kia EV6 (Single RWD (229HP) / Dual AWD (320HP) / GT 577HP / 77.4 kWh battery) logs fault code P0117, drivers commonly observe:
2. Most Likely Causes on Kia EV6
Historical warranty claims and technical repair bulletins for Kia EV6 point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Kia EV6
Read ECT live PID on scanner. If it reads 284°F (140°C) or higher with engine cold, a short to ground exists. on the Kia EV6 equipped with Single RWD (229HP) / Dual AWD (320HP) / GT 577HP / 77.4 kWh battery.
Unplug sensor connector while watching live data. If temperature drops to -40°F (-40°C), the sensor itself is shorted. on the Kia EV6 equipped with Single RWD (229HP) / Dual AWD (320HP) / GT 577HP / 77.4 kWh battery.
If reading stays pegged at max with sensor unplugged, inspect harness for pinch points grounding against engine block. on the Kia EV6 equipped with Single RWD (229HP) / Dual AWD (320HP) / GT 577HP / 77.4 kWh battery.
Allow engine to cool, unscrew old ECT sensor from coolant crossover pipe or thermostat housing, install new OEM sensor with fresh thread sealant. on the Kia EV6 equipped with Single RWD (229HP) / Dual AWD (320HP) / GT 577HP / 77.4 kWh battery.
Bleed air from cooling system, clear DTCs, and verify normal temperature rise on live data. on the Kia EV6 equipped with Single RWD (229HP) / Dual AWD (320HP) / GT 577HP / 77.4 kWh battery.
Equipment for Diagnosing Kia EV6 (P0117)
VVT Oil Control Solenoid Valve
Restores accurate camshaft timing and oil pressure regulation on Kia EV6.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Kia EV6
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Kia EV6:
4. Kia EV6 P0117 FAQs
What causes code P0117 to trigger on a Kia EV6?
On the Kia EV6 (Single RWD (229HP) / Dual AWD (320HP) / GT 577HP / 77.4 kWh battery), P0117 is most frequently caused by ECT sensor internal short to ground or Short circuit to ground in ECT signal wiring harness.
Where is the OBD-II port located on my Kia EV6?
On the Kia EV6, the 16-pin DLC diagnostic connector is located Driver side lower dash bezel interface. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Kia EV6 with code P0117?
No. The ECU thinks the engine is at 280°F+ (overheating) and runs rich or disables cooling fan logic. Given that P0117 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.