P0111 on Kia Telluride
Factory diagnostic protocol and troubleshooting wire for fault code P0111 specifically for the Kia Telluride (2020–2026, 3.8L Lambda II V6 (291HP / 262 lb-ft torque)).
1. Symptoms of P0111 on Kia Telluride
When the Engine Control Module (ECM/PCM) on your Kia Telluride (3.8L Lambda II V6 (291HP / 262 lb-ft torque)) logs fault code P0111, drivers commonly observe:
2. Most Likely Causes on Kia Telluride
Historical warranty claims and technical repair bulletins for Kia Telluride point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Kia Telluride
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0111 to note engine RPM, load, and voltage when the fault triggered. on the Kia Telluride equipped with 3.8L Lambda II V6 (291HP / 262 lb-ft torque).
Inspect the electrical connector and wiring harness related to P0111 for chafing, corrosion, moisture, or pin push-out. on the Kia Telluride equipped with 3.8L Lambda II V6 (291HP / 262 lb-ft torque).
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the Kia Telluride equipped with 3.8L Lambda II V6 (291HP / 262 lb-ft torque).
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the Kia Telluride equipped with 3.8L Lambda II V6 (291HP / 262 lb-ft torque).
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the Kia Telluride equipped with 3.8L Lambda II V6 (291HP / 262 lb-ft torque).
Equipment for Diagnosing Kia Telluride (P0111)
VVT Oil Control Solenoid Valve
Restores accurate camshaft timing and oil pressure regulation on Kia Telluride.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Kia Telluride
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Kia Telluride:
4. Kia Telluride P0111 FAQs
What causes code P0111 to trigger on a Kia Telluride?
On the Kia Telluride (3.8L Lambda II V6 (291HP / 262 lb-ft torque)), P0111 is most frequently caused by Dirty or contaminated IAT sensor or IAT sensor mounted in hot engine air stream.
Where is the OBD-II port located on my Kia Telluride?
On the Kia Telluride, the 16-pin DLC diagnostic connector is located Under driver side dashboard near fuse box panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Kia Telluride with code P0111?
Yes. Minor decrease in fuel economy. Given that P0111 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.