FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0455

Mercedes-Benz GLE GuideLow Severity

P0455 on Mercedes-Benz GLE: Symptoms, Causes & DIY Fix

Official technical diagnostic wire for fault code P0455 (P0455: Evaporative Emission Control System Leak Detected (Gross Leak)) specifically affecting Mercedes-Benz GLE vehicles equipped with 2.0L Turbo / 3.0L Turbo I6 (GLE 450 375HP) / 4.0L V8 GLE 580.

DIY Parts Estimate

$15 - $250 (DIY: $15 - $50)

GLE Direct Fit

Shop Labor Quote

$180 – $380

Based on $185/hr labor

Drivability Status

Drivable (Short Trip)

Low urgency level

Est. DIY Time

45 – 90 Min

Basic hand tools

Check P0455 On Another Mercedes-Benz Model:

Mercedes-Benz C-Class Mercedes-Benz E-Class Mercedes-Benz S-Class Mercedes-Benz GLC Mercedes-Benz GLE Mercedes-Benz GLS Mercedes-Benz G-Class

1. Symptoms of P0455 on Mercedes-Benz GLE

When the Engine Control Module (ECM/PCM) on your Mercedes-Benz GLE (2.0L Turbo / 3.0L Turbo I6 (GLE 450 375HP) / 4.0L V8 GLE 580) logs fault code P0455, drivers commonly observe:

Check Engine Light on on Mercedes-Benz GLE (2.0L Turbo / 3.0L Turbo I6 (GLE 450 375HP) / 4.0L V8 GLE 580)

Gas cap loose warning message on dashboard on Mercedes-Benz GLE (2.0L Turbo / 3.0L Turbo I6 (GLE 450 375HP) / 4.0L V8 GLE 580)

Slight fuel vapor odor near rear of vehicle on Mercedes-Benz GLE (2.0L Turbo / 3.0L Turbo I6 (GLE 450 375HP) / 4.0L V8 GLE 580)

Mercedes-Benz GLE OBD-II Port Location

The 16-pin diagnostic connector is located Driver footwell directly above parking brake pedal. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Mercedes-Benz GLE

Historical warranty claims and technical repair bulletins for Mercedes-Benz GLE point to the following failure distribution:

55%

Missing, loose, or cracked gas cap seal (Mercedes-Benz OEM Part)

25%

Faulty EVAP purge control solenoid (Mercedes-Benz OEM Part)

12%

Stuck open EVAP vent valve (Mercedes-Benz OEM Part)

Cracked EVAP charcoal canister vapor hose (Mercedes-Benz OEM Part)

3. Step-by-Step DIY Repair Guide for Mercedes-Benz GLE

Inspect and Tighten the Gas Cap

Remove gas cap, inspect rubber O-ring for cracks, tighten until it clicks 3 times. on the Mercedes-Benz GLE equipped with 2.0L Turbo / 3.0L Turbo I6 (GLE 450 375HP) / 4.0L V8 GLE 580.

Required Tool: None

Replace Gas Cap with OEM Replacement

If the cap rubber is dried or cracked, replace with genuine OEM cap ($15). on the Mercedes-Benz GLE equipped with 2.0L Turbo / 3.0L Turbo I6 (GLE 450 375HP) / 4.0L V8 GLE 580.

Required Tool: New OEM Gas Cap

Test EVAP Purge Solenoid Under Hood

Disconnect electrical plug and vacuum hose. Apply 12V; verify valve seals tight when unpowered. on the Mercedes-Benz GLE equipped with 2.0L Turbo / 3.0L Turbo I6 (GLE 450 375HP) / 4.0L V8 GLE 580.

Required Tool: 12V Probe, Vacuum Pump

Inspect EVAP Canister Vent Valve Near Gas Tank

Check vent valve for road salt corrosion or spider nest clogs. on the Mercedes-Benz GLE equipped with 2.0L Turbo / 3.0L Turbo I6 (GLE 450 375HP) / 4.0L V8 GLE 580.

Required Tool: Flashlight, Jack Stands

Smoke Test EVAP System

Pump mineral oil smoke into EVAP port to reveal any hairline cracked lines. on the Mercedes-Benz GLE equipped with 2.0L Turbo / 3.0L Turbo I6 (GLE 450 375HP) / 4.0L V8 GLE 580.

Required Tool: EVAP Smoke Machine

4. Mercedes-Benz GLE P0455 FAQs

What causes code P0455 to trigger on a Mercedes-Benz GLE?

On the Mercedes-Benz GLE (2.0L Turbo / 3.0L Turbo I6 (GLE 450 375HP) / 4.0L V8 GLE 580), P0455 is most frequently caused by Missing, loose, or cracked gas cap seal or Faulty EVAP purge control solenoid. Factory sensor degradation or wiring harness wear near the engine bay are common factors.

Can I safely drive my Mercedes-Benz GLE with code P0455?

Yes. Completely safe to drive, but emissions test will fail. Given that P0455 carries a Low severity rating on Mercedes-Benz vehicles, we advise performing diagnostic scanning via the OBD-II port located driver footwell directly above parking brake pedal before extended highway driving.

Where is the diagnostic port located on the Mercedes-Benz GLE?

The 16-pin OBD-II DLC connector on the Mercedes-Benz GLE is situated driver footwell directly above parking brake pedal. It requires no special tools to plug in a standard scanner.

How much does it cost to fix P0455 on a Mercedes-Benz GLE?

DIY replacement parts typically range between $15 - $250 (DIY: $15 - $50). If serviced at an authorized Mercedes-Benz dealership, expect an additional $120–$250 in professional labor based on their $185/hr hourly rate.