MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

B1318 on Nissan Rogue

Battery Voltage Low

Factory diagnostic protocol and troubleshooting wire for fault code B1318 specifically for the Nissan Rogue (2021–2026, 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft)).

Verified OEM Telemetry & Field Repair Tree
Nissan Rogue2021–2026
Nissan Rogue
SUV1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft)
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
Rogue SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. Repair Cost
$80 - $250 (DIY: $0 - $180)
Parts & Labor DIY
Check B1318 On Another Nissan Model:
Diagnose B1318 on Specific Rogue Model Year:

1. Symptoms of B1318 on Nissan Rogue

When the Engine Control Module (ECM/PCM) on your Nissan Rogue (1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft)) logs fault code B1318, drivers commonly observe:

Battery warning light on dash on Nissan Rogue (1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft))
Slow engine cranking or rapid clicking starter on Nissan Rogue (1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft))
Random electrical accessories (radio, power windows) shutting off on Nissan Rogue (1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft))
Multiple U-codes and B-codes stored simultaneously on Nissan Rogue (1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft))
Nissan Rogue OBD-II Port Location
The 16-pin diagnostic connector is located Driver lower dash trim near driver left foot. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Nissan Rogue

Historical warranty claims and technical repair bulletins for Nissan Rogue point to the following failure distribution:

55%
Failing 12V automotive battery (sulfated plates or dead cell) (Nissan OEM Part)
25%
Faulty alternator not charging battery (>13.5V) (Nissan OEM Part)
12%
Corroded or loose battery cable terminals (Nissan OEM Part)
8%
Parasitic battery drain drawing power while parked (Nissan OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Nissan Rogue.

3. Step-by-Step DIY Repair Guide for Nissan Rogue

01
Test Battery Open-Circuit Voltage

Measure resting battery voltage with engine off. Normal is 12.6V. If under 12.0V, battery is discharged. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).

Required Tool: Digital Multimeter
02
Clean Battery Posts and Terminals

Remove corrosion with baking soda solution and wire brush, tighten terminal clamps firmly. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).

Required Tool: Terminal Cleaning Brush, 10mm Wrench
03
Test Alternator Charging Voltage

Start engine and measure voltage across battery. Normal charging voltage is 13.8V to 14.6V. If below 13.0V, alternator has failed. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).

Required Tool: Multimeter
04
Replace Battery or Alternator as Indicated

Install new high-CCA AGM or flooded battery, or replace alternator. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).

Required Tool: Socket Set, Wrenches
05
Clear Trouble Codes & Reset BMS

Clear DTCs and perform Battery Management System (BMS) reset if equipped. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).

Required Tool: OBD-II Scan Tool
Recommended Parts & Testing Tools

Equipment for Diagnosing Nissan Rogue (B1318)

Prime Fast Delivery & Verified Fitment
Direct-Fit Replacement Part

Nissan Rogue OEM Replacement Sensor

4.7 / 5.0 (Verified Fit)

Direct-fit replacement assembly engineered to OEM tolerances for Nissan Rogue.

$45 – $95 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Nissan RogueVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Nissan Rogue

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Nissan Rogue:

4. Nissan Rogue B1318 FAQs

What causes code B1318 to trigger on a Nissan Rogue?

On the Nissan Rogue (1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft)), B1318 is most frequently caused by Failing 12V automotive battery (sulfated plates or dead cell) or Faulty alternator not charging battery (>13.5V).

Where is the OBD-II port located on my Nissan Rogue?

On the Nissan Rogue, the 16-pin DLC diagnostic connector is located Driver lower dash trim near driver left foot. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Nissan Rogue with code B1318?

Caution. Low voltage (<10V) causes random module dropouts, flickering dash lights, and stalling. Given that B1318 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.