U0102 on Nissan Rogue
Factory diagnostic protocol and troubleshooting wire for fault code U0102 specifically for the Nissan Rogue (2021–2026, 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft)).
1. Symptoms of U0102 on Nissan Rogue
When the Engine Control Module (ECM/PCM) on your Nissan Rogue (1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft)) logs fault code U0102, drivers commonly observe:
2. Most Likely Causes on Nissan Rogue
Historical warranty claims and technical repair bulletins for Nissan Rogue point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Nissan Rogue
Inspect ATC / 4WD fuses with test light. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).
Check module under driver dash or seat for water intrusion. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).
Verify 2.5V CAN signals reach the module. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).
Install replacement module and clear trouble codes. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).
Equipment for Diagnosing Nissan Rogue (U0102)
Nissan Rogue OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Nissan Rogue.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Nissan Rogue
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Nissan Rogue:
4. Nissan Rogue U0102 FAQs
What causes code U0102 to trigger on a Nissan Rogue?
On the Nissan Rogue (1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft)), U0102 is most frequently caused by Corroded TCCM power/ground wiring under vehicle or Blown 4WD / TCCM fuse in engine fuse panel.
Where is the OBD-II port located on my Nissan Rogue?
On the Nissan Rogue, the 16-pin DLC diagnostic connector is located Driver lower dash trim near driver left foot. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Nissan Rogue with code U0102?
Yes, in 2WD. 4WD and Auto 4x4 functions will be inoperative. Given that U0102 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.