MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0705 on Nissan Sentra

Transmission Range Sensor Circuit Malfunction (PRNDL Input)

Factory diagnostic protocol and troubleshooting wire for fault code P0705 specifically for the Nissan Sentra (2020–2026, 2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic)).

Verified OEM Telemetry & Field Repair Tree
Nissan Sentra2020–2026
Nissan Sentra
Sedan2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic)
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
Sentra SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Drivable (Short Trip)
High urgency level
Est. Repair Cost
$120 - $450 (DIY: $40 - $160)
Parts & Labor DIY
Check P0705 On Another Nissan Model:
Diagnose P0705 on Specific Sentra Model Year:

1. Symptoms of P0705 on Nissan Sentra

When the Engine Control Module (ECM/PCM) on your Nissan Sentra (2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic)) logs fault code P0705, drivers commonly observe:

Check Engine Light on on Nissan Sentra (2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic))
Vehicle will not crank/start in Park (starts only in Neutral) on Nissan Sentra (2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic))
Gear indicator on dashboard (P R N D 1 2) is blank or displays wrong gear on Nissan Sentra (2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic))
Transmission shifts harshly or goes into 3rd gear limp mode on Nissan Sentra (2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic))
Reverse backup lights fail to illuminate on Nissan Sentra (2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic))
Nissan Sentra OBD-II Port Location
The 16-pin diagnostic connector is located Driver lower dash cover above brake pedal. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Nissan Sentra

Historical warranty claims and technical repair bulletins for Nissan Sentra point to the following failure distribution:

55%
Misaligned or faulty Transmission Range Sensor / Neutral Safety Switch (NSS) (Nissan OEM Part)
25%
Corroded or water-logged connector on transmission side (Nissan OEM Part)
12%
Stretched or misadjusted shift linkage cable (Nissan OEM Part)
8%
Broken internal switch contacts (Nissan OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Nissan Sentra.

3. Step-by-Step DIY Repair Guide for Nissan Sentra

01
Check PRNDL Live Data

Move gear selector through all positions while monitoring scan tool TR PID to see which gear positions fail to register. on the Nissan Sentra equipped with 2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic).

Required Tool: OBD-II Scanner
02
Inspect Shift Cable Alignment

Ensure the mechanical shift linkage fully clicks the transmission lever into the physical detent for Park and Neutral. on the Nissan Sentra equipped with 2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic).

Required Tool: Pliers, Socket Set
03
Test Neutral Safety Switch Continuity

Use multimeter to check continuity across switch pins in Park, Reverse, Neutral, and Drive. on the Nissan Sentra equipped with 2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic).

Required Tool: Digital Multimeter
04
Replace or Re-align Range Sensor

Loosen mounting bolts, use alignment pin to align sensor slot with transmission shaft in Neutral, torque bolts, or install new OEM sensor. on the Nissan Sentra equipped with 2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic).

Required Tool: 10mm/12mm Sockets, Alignment Pin
05
Clear Trouble Codes and Verify Starting

Clear DTCs and confirm engine starts in Park and Neutral, reverse lights activate, and gear display is accurate. on the Nissan Sentra equipped with 2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic).

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Nissan Sentra (P0705)

Prime Fast Delivery & Verified Fitment
Direct-Fit Replacement Part

Nissan Sentra OEM Replacement Sensor

4.7 / 5.0 (Verified Fit)

Direct-fit replacement assembly engineered to OEM tolerances for Nissan Sentra.

$45 – $95 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Nissan SentraVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Nissan Sentra

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Nissan Sentra:

4. Nissan Sentra P0705 FAQs

What causes code P0705 to trigger on a Nissan Sentra?

On the Nissan Sentra (2.0L DOHC 16V 4-Cyl (149HP / CVT Xtronic)), P0705 is most frequently caused by Misaligned or faulty Transmission Range Sensor / Neutral Safety Switch (NSS) or Corroded or water-logged connector on transmission side.

Where is the OBD-II port located on my Nissan Sentra?

On the Nissan Sentra, the 16-pin DLC diagnostic connector is located Driver lower dash cover above brake pedal. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Nissan Sentra with code P0705?

Caution. Vehicle may not start in Park, backup lights may not work, and transmission may lock in Limp Mode. Given that P0705 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.