P0112 on RAM ProMaster
Factory diagnostic protocol and troubleshooting wire for fault code P0112 specifically for the RAM ProMaster (2020–2026, 3.6L Pentastar V6 (280HP) / 3.0L EcoDiesel (174HP)).
1. Symptoms of P0112 on RAM ProMaster
When the Engine Control Module (ECM/PCM) on your RAM ProMaster (3.6L Pentastar V6 (280HP) / 3.0L EcoDiesel (174HP)) logs fault code P0112, drivers commonly observe:
2. Most Likely Causes on RAM ProMaster
Historical warranty claims and technical repair bulletins for RAM ProMaster point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for RAM ProMaster
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0112 to note engine RPM, load, and voltage when the fault triggered. on the RAM ProMaster equipped with 3.6L Pentastar V6 (280HP) / 3.0L EcoDiesel (174HP).
Inspect the electrical connector and wiring harness related to P0112 for chafing, corrosion, moisture, or pin push-out. on the RAM ProMaster equipped with 3.6L Pentastar V6 (280HP) / 3.0L EcoDiesel (174HP).
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the RAM ProMaster equipped with 3.6L Pentastar V6 (280HP) / 3.0L EcoDiesel (174HP).
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the RAM ProMaster equipped with 3.6L Pentastar V6 (280HP) / 3.0L EcoDiesel (174HP).
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the RAM ProMaster equipped with 3.6L Pentastar V6 (280HP) / 3.0L EcoDiesel (174HP).
Equipment for Diagnosing RAM ProMaster (P0112)
VVT Oil Control Solenoid Valve
Restores accurate camshaft timing and oil pressure regulation on RAM ProMaster.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on RAM ProMaster
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the RAM ProMaster:
4. RAM ProMaster P0112 FAQs
What causes code P0112 to trigger on a RAM ProMaster?
On the RAM ProMaster (3.6L Pentastar V6 (280HP) / 3.0L EcoDiesel (174HP)), P0112 is most frequently caused by IAT sensor shorted to ground or Damaged wiring harness.
Where is the OBD-II port located on my RAM ProMaster?
On the RAM ProMaster, the 16-pin DLC diagnostic connector is located Driver side lower dash panel near hood release. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my RAM ProMaster with code P0112?
Yes. ECM assumes intake air is 280°F+. Given that P0112 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.