U0104 on Subaru Outback
Factory diagnostic protocol and troubleshooting wire for fault code U0104 specifically for the Subaru Outback (2020–2026, 2.5L Boxer-4 (FB25D 182HP) / 2.4L Turbocharged Boxer-4 (FA24F 260HP XT)).
1. Symptoms of U0104 on Subaru Outback
When the Engine Control Module (ECM/PCM) on your Subaru Outback (2.5L Boxer-4 (FB25D 182HP) / 2.4L Turbocharged Boxer-4 (FA24F 260HP XT)) logs fault code U0104, drivers commonly observe:
2. Most Likely Causes on Subaru Outback
Historical warranty claims and technical repair bulletins for Subaru Outback point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Subaru Outback
Clean snow, ice, mud, or dead bugs off front radar emblem. on the Subaru Outback equipped with 2.5L Boxer-4 (FB25D 182HP) / 2.4L Turbocharged Boxer-4 (FA24F 260HP XT).
Verify power feed to radar sensor. on the Subaru Outback equipped with 2.5L Boxer-4 (FB25D 182HP) / 2.4L Turbocharged Boxer-4 (FA24F 260HP XT).
Execute optical/radar alignment procedure if bumper was removed. on the Subaru Outback equipped with 2.5L Boxer-4 (FB25D 182HP) / 2.4L Turbocharged Boxer-4 (FA24F 260HP XT).
Clear DTCs and test cruise on highway. on the Subaru Outback equipped with 2.5L Boxer-4 (FB25D 182HP) / 2.4L Turbocharged Boxer-4 (FA24F 260HP XT).
Equipment for Diagnosing Subaru Outback (U0104)
Subaru Outback OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Subaru Outback.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Subaru Outback
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Subaru Outback:
4. Subaru Outback U0104 FAQs
What causes code U0104 to trigger on a Subaru Outback?
On the Subaru Outback (2.5L Boxer-4 (FB25D 182HP) / 2.4L Turbocharged Boxer-4 (FA24F 260HP XT)), U0104 is most frequently caused by Blocked or dirty front radar sensor in grille/bumper or Blown radar module fuse.
Where is the OBD-II port located on my Subaru Outback?
On the Subaru Outback, the 16-pin DLC diagnostic connector is located Under driver dash, left of steering column above pedals. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Subaru Outback with code U0104?
Yes. Normal driving is unaffected, but Adaptive Cruise Control will not engage. Given that U0104 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.