P0202 on Subaru WRX
Factory diagnostic protocol and troubleshooting wire for fault code P0202 specifically for the Subaru WRX (2022–2026, 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI)).
1. Symptoms of P0202 on Subaru WRX
When the Engine Control Module (ECM/PCM) on your Subaru WRX (2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI)) logs fault code P0202, drivers commonly observe:
2. Most Likely Causes on Subaru WRX
Historical warranty claims and technical repair bulletins for Subaru WRX point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Subaru WRX
Measure resistance across injector 2 terminals. Compare to Cylinder 1 and 3 (spec: 12–16 ohms). on the Subaru WRX equipped with 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI).
Check for 12V on power wire and verify ground pulsing using a noid light while cranking. on the Subaru WRX equipped with 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI).
Depressurize fuel system, lift rail, swap injector, lube new O-rings, and reinstall rail. on the Subaru WRX equipped with 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI).
Clear DTC memory and monitor misfire counters on live data. on the Subaru WRX equipped with 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI).
Equipment for Diagnosing Subaru WRX (P0202)
Subaru WRX OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Subaru WRX.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Subaru WRX
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Subaru WRX:
4. Subaru WRX P0202 FAQs
What causes code P0202 to trigger on a Subaru WRX?
On the Subaru WRX (2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI)), P0202 is most frequently caused by Cylinder 2 fuel injector internal coil failure or Broken wiring or corroded connector pin on Cylinder 2 harness.
Where is the OBD-II port located on my Subaru WRX?
On the Subaru WRX, the 16-pin DLC diagnostic connector is located Driver lower dash near fuse panel access door. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Subaru WRX with code P0202?
No. Cylinder 2 is completely disabled by an electrical circuit fault, causing hard misfires. Given that P0202 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.