FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.
P0455TeslaTesla Model 3 GuideLow Severity

P0455 on Tesla Model 3: Symptoms, Causes & DIY Fix

Official technical diagnostic wire for fault code P0455 (P0455: Evaporative Emission Control System Leak Detected (Gross Leak)) specifically affecting Tesla Model 3 vehicles equipped with Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP).

DIY Parts Estimate
$15 - $250 (DIY: $15 - $50)
Model 3 Direct Fit
Shop Labor Quote
$180 – $380
Based on $195/hr labor
Drivability Status
Drivable (Short Trip)
Low urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0455 On Another Tesla Model:
Tesla Model 3Tesla Model YTesla Model STesla Model XTesla Cybertruck

1. Symptoms of P0455 on Tesla Model 3

When the Engine Control Module (ECM/PCM) on your Tesla Model 3 (Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP)) logs fault code P0455, drivers commonly observe:

Check Engine Light on on Tesla Model 3 (Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP))
Gas cap loose warning message on dashboard on Tesla Model 3 (Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP))
Slight fuel vapor odor near rear of vehicle on Tesla Model 3 (Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP))
Tesla Model 3 OBD-II Port Location
The 16-pin diagnostic connector is located Under driver dash (OBD-II port integrates with internal CAN gateway). Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Tesla Model 3

Historical warranty claims and technical repair bulletins for Tesla Model 3 point to the following failure distribution:

55%
Missing, loose, or cracked gas cap seal (Tesla OEM Part)
25%
Faulty EVAP purge control solenoid (Tesla OEM Part)
12%
Stuck open EVAP vent valve (Tesla OEM Part)
8%
Cracked EVAP charcoal canister vapor hose (Tesla OEM Part)

3. Step-by-Step DIY Repair Guide for Tesla Model 3

01
Inspect and Tighten the Gas Cap

Remove gas cap, inspect rubber O-ring for cracks, tighten until it clicks 3 times. on the Tesla Model 3 equipped with Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP).

Required Tool: None
02
Replace Gas Cap with OEM Replacement

If the cap rubber is dried or cracked, replace with genuine OEM cap ($15). on the Tesla Model 3 equipped with Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP).

Required Tool: New OEM Gas Cap
03
Test EVAP Purge Solenoid Under Hood

Disconnect electrical plug and vacuum hose. Apply 12V; verify valve seals tight when unpowered. on the Tesla Model 3 equipped with Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP).

Required Tool: 12V Probe, Vacuum Pump
04
Inspect EVAP Canister Vent Valve Near Gas Tank

Check vent valve for road salt corrosion or spider nest clogs. on the Tesla Model 3 equipped with Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP).

Required Tool: Flashlight, Jack Stands
05
Smoke Test EVAP System

Pump mineral oil smoke into EVAP port to reveal any hairline cracked lines. on the Tesla Model 3 equipped with Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP).

Required Tool: EVAP Smoke Machine

4. Tesla Model 3 P0455 FAQs

What causes code P0455 to trigger on a Tesla Model 3?

On the Tesla Model 3 (Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP)), P0455 is most frequently caused by Missing, loose, or cracked gas cap seal or Faulty EVAP purge control solenoid. Factory sensor degradation or wiring harness wear near the engine bay are common factors.

Can I safely drive my Tesla Model 3 with code P0455?

Yes. Completely safe to drive, but emissions test will fail. Given that P0455 carries a Low severity rating on Tesla vehicles, we advise performing diagnostic scanning via the OBD-II port located under driver dash (obd-ii port integrates with internal can gateway) before extended highway driving.

Where is the diagnostic port located on the Tesla Model 3?

The 16-pin OBD-II DLC connector on the Tesla Model 3 is situated under driver dash (obd-ii port integrates with internal can gateway). It requires no special tools to plug in a standard scanner.

How much does it cost to fix P0455 on a Tesla Model 3?

DIY replacement parts typically range between $15 - $250 (DIY: $15 - $50). If serviced at an authorized Tesla dealership, expect an additional $120–$250 in professional labor based on their $195/hr hourly rate.