FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0507 on Tesla Model X: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0507 (Idle Control System RPM Higher Than Expected - Diagnosis) specifically on the Tesla Model X (2020–2026, Dual Motor AWD / Tri-Motor Plaid (1,020 HP Falcon Wing Doors)).

2020–2026
Model XEV
Sensor Voltage Ref
0.1V – 5.0V Ref
Model X SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0507 On Another Tesla Model:

1. Symptoms of P0507 on Tesla Model X

When the Engine Control Module (ECM/PCM) on your Tesla Model X (Dual Motor AWD / Tri-Motor Plaid (1,020 HP Falcon Wing Doors)) logs fault code P0507, drivers commonly observe:

Engine idles at 1,000+ RPM in park/neutral on Tesla Model X (Dual Motor AWD / Tri-Motor Plaid (1,020 HP Falcon Wing Doors))
RPM surges or hunts at red lights on Tesla Model X (Dual Motor AWD / Tri-Motor Plaid (1,020 HP Falcon Wing Doors))
Check Engine Light illuminated on Tesla Model X (Dual Motor AWD / Tri-Motor Plaid (1,020 HP Falcon Wing Doors))
Tesla Model X OBD-II Port Location
The 16-pin diagnostic connector is located Driver side lower instrument panel trim. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Tesla Model X

Historical warranty claims and technical repair bulletins for Tesla Model X point to the following failure distribution:

55%
Intake manifold vacuum leak (Tesla OEM Part)
25%
Carbon buildup causing sticky electronic throttle body (Tesla OEM Part)
12%
Uncalibrated idle air volume after battery disconnect (Tesla OEM Part)
8%
Faulty PCV valve stuck open (Tesla OEM Part)

3. Step-by-Step DIY Repair Guide for Tesla Model X

01
Check for Unmetered Vacuum Leaks

Spray brake cleaner around intake manifold gaskets; an RPM change reveals the leak location. on the Tesla Model X equipped with Dual Motor AWD / Tri-Motor Plaid (1,020 HP Falcon Wing Doors).

02
Clean Throttle Body & Carbon Deposits

Gently clean carbon soot around throttle blade using throttle cleaner and microfiber towel. on the Tesla Model X equipped with Dual Motor AWD / Tri-Motor Plaid (1,020 HP Falcon Wing Doors).

03
Perform Idle Air Volume Relearn Procedure

Follow vehicle-specific ignition key on/off timing sequence or use OBD scanner to reset baseline idle. on the Tesla Model X equipped with Dual Motor AWD / Tri-Motor Plaid (1,020 HP Falcon Wing Doors).

Other Common Fault Codes on Tesla Model X

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Tesla Model X:

4. Tesla Model X P0507 FAQs

What causes code P0507 to trigger on a Tesla Model X?

On the Tesla Model X (Dual Motor AWD / Tri-Motor Plaid (1,020 HP Falcon Wing Doors)), P0507 is most frequently caused by Intake manifold vacuum leak or Carbon buildup causing sticky electronic throttle body.

Where is the OBD-II port located on my Tesla Model X?

On the Tesla Model X, the 16-pin DLC diagnostic connector is located Driver side lower instrument panel trim. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Tesla Model X with code P0507?

Driveable, but braking distance may increase slightly due to high engine idle. Given that P0507 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.