MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0341 on Tesla Model Y

Camshaft Position Sensor A Circuit Range/Performance (Bank 1)

Factory diagnostic protocol and troubleshooting wire for fault code P0341 specifically for the Tesla Model Y (2020–2026, Dual Motor AWD Long Range / Performance (0-60 in 3.5s)).

Verified OEM Telemetry & Field Repair Tree
Tesla Model Y2020–2026
Tesla Model Y
EVDual Motor AWD Long Range / Performance (0-60 in 3.5s)
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
Model Y SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Not Recommended
High urgency level
Est. Repair Cost
$120 - $750 (DIY: $35 - $120)
Parts & Labor DIY
Check P0341 On Another Tesla Model:
Diagnose P0341 on Specific Model Y Model Year:

1. Symptoms of P0341 on Tesla Model Y

When the Engine Control Module (ECM/PCM) on your Tesla Model Y (Dual Motor AWD Long Range / Performance (0-60 in 3.5s)) logs fault code P0341, drivers commonly observe:

Check Engine Light on on Tesla Model Y (Dual Motor AWD Long Range / Performance (0-60 in 3.5s))
Extended engine cranking before starting (5–8 seconds) on Tesla Model Y (Dual Motor AWD Long Range / Performance (0-60 in 3.5s))
Engine lacks high-RPM power or enters Limp Mode (VTEC / VVT disabled) on Tesla Model Y (Dual Motor AWD Long Range / Performance (0-60 in 3.5s))
Rough idling and rattling sound from timing cover area on startup on Tesla Model Y (Dual Motor AWD Long Range / Performance (0-60 in 3.5s))
Tesla Model Y OBD-II Port Location
The 16-pin diagnostic connector is located Beneath steering wheel lower cover assembly. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Tesla Model Y

Historical warranty claims and technical repair bulletins for Tesla Model Y point to the following failure distribution:

55%
Stretched timing chain or worn timing belt jumped one tooth (Tesla OEM Part)
25%
Failed Variable Valve Timing (VVT) actuator phaser or oil control valve (OCV) (Tesla OEM Part)
12%
Faulty Camshaft Position Sensor (CMP) (Tesla OEM Part)
8%
Low engine oil level or severely sludged engine oil blocking VVT passages (Tesla OEM Part)
8%
Damaged reluctor tone ring on camshaft (Tesla OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Tesla Model Y.

3. Step-by-Step DIY Repair Guide for Tesla Model Y

01
Check Engine Oil Level & Viscosity

VVT systems require correct oil pressure. Check oil level on dipstick; if dirty or low, change oil and filter with OEM-grade synthetic. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).

Required Tool: Dipstick, Oil Drain Pan
02
Scan VVT Cam Angle Telemetry

Check actual vs desired camshaft phase angle on scan tool. If cam angle lags significantly behind target, timing chain stretch or VVT phaser failure is indicated. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).

Required Tool: OBD-II Scan Tool with Live Data
03
Inspect VVT Solenoid (Oil Control Valve)

Remove VVT solenoid, inspect screen for metal debris or sludge, and test 12V actuation with bench power. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).

Required Tool: 10mm Socket, 12V Power Source
04
Test Camshaft Position Sensor

Check 5V reference, ground, and 5V square-wave signal with lab scope or multimeter. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).

Required Tool: Digital Multimeter or Oscilloscope
05
Inspect Timing Chain Tensioner & Marks

If sensor and VVT solenoid test good, remove valve cover to inspect timing chain slack and alignment marks. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).

Required Tool: Socket Set, Torque Wrench
Recommended Parts & Testing Tools

Equipment for Diagnosing Tesla Model Y (P0341)

Prime Fast Delivery & Verified Fitment
Direct-Fit Replacement Part

Tesla Model Y OEM Replacement Sensor

4.7 / 5.0 (Verified Fit)

Direct-fit replacement assembly engineered to OEM tolerances for Tesla Model Y.

$45 – $95 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Tesla Model YVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Tesla Model Y

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Tesla Model Y:

4. Tesla Model Y P0341 FAQs

What causes code P0341 to trigger on a Tesla Model Y?

On the Tesla Model Y (Dual Motor AWD Long Range / Performance (0-60 in 3.5s)), P0341 is most frequently caused by Stretched timing chain or worn timing belt jumped one tooth or Failed Variable Valve Timing (VVT) actuator phaser or oil control valve (OCV).

Where is the OBD-II port located on my Tesla Model Y?

On the Tesla Model Y, the 16-pin DLC diagnostic connector is located Beneath steering wheel lower cover assembly. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Tesla Model Y with code P0341?

No. Stretched timing chain or incorrect camshaft timing can cause catastrophic valve-to-piston contact. Given that P0341 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.