P0705 on Toyota Camry TRD
Factory diagnostic protocol and troubleshooting wire for fault code P0705 specifically for the Toyota Camry TRD (2020–2025, 3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust)).
1. Symptoms of P0705 on Toyota Camry TRD
When the Engine Control Module (ECM/PCM) on your Toyota Camry TRD (3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust)) logs fault code P0705, drivers commonly observe:
2. Most Likely Causes on Toyota Camry TRD
Historical warranty claims and technical repair bulletins for Toyota Camry TRD point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Toyota Camry TRD
Move gear selector through all positions while monitoring scan tool TR PID to see which gear positions fail to register. on the Toyota Camry TRD equipped with 3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust).
Ensure the mechanical shift linkage fully clicks the transmission lever into the physical detent for Park and Neutral. on the Toyota Camry TRD equipped with 3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust).
Use multimeter to check continuity across switch pins in Park, Reverse, Neutral, and Drive. on the Toyota Camry TRD equipped with 3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust).
Loosen mounting bolts, use alignment pin to align sensor slot with transmission shaft in Neutral, torque bolts, or install new OEM sensor. on the Toyota Camry TRD equipped with 3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust).
Clear DTCs and confirm engine starts in Park and Neutral, reverse lights activate, and gear display is accurate. on the Toyota Camry TRD equipped with 3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust).
Equipment for Diagnosing Toyota Camry TRD (P0705)
Toyota Camry TRD OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Toyota Camry TRD.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Toyota Camry TRD
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Toyota Camry TRD:
4. Toyota Camry TRD P0705 FAQs
What causes code P0705 to trigger on a Toyota Camry TRD?
On the Toyota Camry TRD (3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust)), P0705 is most frequently caused by Misaligned or faulty Transmission Range Sensor / Neutral Safety Switch (NSS) or Corroded or water-logged connector on transmission side.
Where is the OBD-II port located on my Toyota Camry TRD?
On the Toyota Camry TRD, the 16-pin DLC diagnostic connector is located Driver footwell lower knee bolster panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Toyota Camry TRD with code P0705?
Caution. Vehicle may not start in Park, backup lights may not work, and transmission may lock in Limp Mode. Given that P0705 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.