MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0155 on Toyota Highlander

O2 Sensor Heater Circuit Malfunction (Bank 2 Sensor 1)

Factory diagnostic protocol and troubleshooting wire for fault code P0155 specifically for the Toyota Highlander (2020–2026, 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid).

Verified OEM Telemetry & Field Repair Tree
Toyota Highlander2020–2026
Toyota Highlander
SUV2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
Highlander SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. Repair Cost
$120 - $350 (DIY: $45 - $120)
Parts & Labor DIY
Check P0155 On Another Toyota Model:
Diagnose P0155 on Specific Highlander Model Year:

1. Symptoms of P0155 on Toyota Highlander

When the Engine Control Module (ECM/PCM) on your Toyota Highlander (2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid) logs fault code P0155, drivers commonly observe:

Check Engine Light on immediately after cold start on Toyota Highlander (2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid)
Slightly increased cold-start emissions on Toyota Highlander (2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid)
No major driving performance issues once engine reaches full operating temperature on Toyota Highlander (2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid)
Toyota Highlander OBD-II Port Location
The 16-pin diagnostic connector is located Under driver steering column near kick panel. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Toyota Highlander

Historical warranty claims and technical repair bulletins for Toyota Highlander point to the following failure distribution:

55%
Burnt-out heating element inside the Bank 2 Sensor 1 O2 sensor (Toyota OEM Part)
25%
Blown O2 heater fuse in under-hood fuse block (Toyota OEM Part)
12%
Corroded or broken heater power/ground wiring (Toyota OEM Part)
8%
Faulty heater driver circuit in the PCM (Toyota OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Toyota Highlander.

3. Step-by-Step DIY Repair Guide for Toyota Highlander

01
Check O2 Heater Fuse

Inspect the O2 HTR fuse in the engine fuse box with a test light or multimeter. on the Toyota Highlander equipped with 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid.

Required Tool: Fuse Puller, Test Light
02
Test Heater Resistance on Bank 2 Sensor 1

Unplug the sensor connector and measure resistance between the two heater pins. An open circuit (infinite ohms / OL) confirms a dead internal heater. on the Toyota Highlander equipped with 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid.

Required Tool: Digital Multimeter
03
Replace Bank 2 Upstream O2 Sensor

Remove faulty sensor and install a new OEM oxygen sensor with built-in heater. on the Toyota Highlander equipped with 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid.

Required Tool: 22mm O2 Sensor Socket, Ratchet
04
Clear Codes and Perform Cold Start Verification

Clear DTCs and allow engine to cool down, then restart to confirm P0155 does not return. on the Toyota Highlander equipped with 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid.

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Toyota Highlander (P0155)

Prime Fast Delivery & Verified Fitment
Direct-Fit Replacement Part

Toyota Highlander OEM Replacement Sensor

4.7 / 5.0 (Verified Fit)

Direct-fit replacement assembly engineered to OEM tolerances for Toyota Highlander.

$45 – $95 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Toyota HighlanderVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Toyota Highlander

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Toyota Highlander:

4. Toyota Highlander P0155 FAQs

What causes code P0155 to trigger on a Toyota Highlander?

On the Toyota Highlander (2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid), P0155 is most frequently caused by Burnt-out heating element inside the Bank 2 Sensor 1 O2 sensor or Blown O2 heater fuse in under-hood fuse block.

Where is the OBD-II port located on my Toyota Highlander?

On the Toyota Highlander, the 16-pin DLC diagnostic connector is located Under driver steering column near kick panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Toyota Highlander with code P0155?

Yes. The sensor will take longer to warm up, causing brief open-loop fuel delay on cold starts. Given that P0155 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.