FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.
P0455ToyotaToyota Tundra GuideLow Severity

P0455 on Toyota Tundra: Symptoms, Causes & DIY Fix

Official technical diagnostic wire for fault code P0455 (P0455: Evaporative Emission Control System Leak Detected (Gross Leak)) specifically affecting Toyota Tundra vehicles equipped with 3.4L Twin-Turbo V6 (V35A-FTS 389HP) / i-FORCE MAX Hybrid (437HP).

DIY Parts Estimate
$15 - $250 (DIY: $15 - $50)
Tundra Direct Fit
Shop Labor Quote
$180 – $380
Based on $110/hr labor
Drivability Status
Drivable (Short Trip)
Low urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0455 On Another Toyota Model:
Toyota CamryToyota Camry HybridToyota Camry TRDToyota CorollaToyota RAV4Toyota HighlanderToyota Grand HighlanderToyota TacomaToyota TundraToyota 4RunnerToyota CrownToyota PriusToyota Land Cruiser

1. Symptoms of P0455 on Toyota Tundra

When the Engine Control Module (ECM/PCM) on your Toyota Tundra (3.4L Twin-Turbo V6 (V35A-FTS 389HP) / i-FORCE MAX Hybrid (437HP)) logs fault code P0455, drivers commonly observe:

Check Engine Light on on Toyota Tundra (3.4L Twin-Turbo V6 (V35A-FTS 389HP) / i-FORCE MAX Hybrid (437HP))
Gas cap loose warning message on dashboard on Toyota Tundra (3.4L Twin-Turbo V6 (V35A-FTS 389HP) / i-FORCE MAX Hybrid (437HP))
Slight fuel vapor odor near rear of vehicle on Toyota Tundra (3.4L Twin-Turbo V6 (V35A-FTS 389HP) / i-FORCE MAX Hybrid (437HP))
Toyota Tundra OBD-II Port Location
The 16-pin diagnostic connector is located Driver side lower dash assembly near parking brake. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Toyota Tundra

Historical warranty claims and technical repair bulletins for Toyota Tundra point to the following failure distribution:

55%
Missing, loose, or cracked gas cap seal (Toyota OEM Part)
25%
Faulty EVAP purge control solenoid (Toyota OEM Part)
12%
Stuck open EVAP vent valve (Toyota OEM Part)
8%
Cracked EVAP charcoal canister vapor hose (Toyota OEM Part)

3. Step-by-Step DIY Repair Guide for Toyota Tundra

01
Inspect and Tighten the Gas Cap

Remove gas cap, inspect rubber O-ring for cracks, tighten until it clicks 3 times. on the Toyota Tundra equipped with 3.4L Twin-Turbo V6 (V35A-FTS 389HP) / i-FORCE MAX Hybrid (437HP).

Required Tool: None
02
Replace Gas Cap with OEM Replacement

If the cap rubber is dried or cracked, replace with genuine OEM cap ($15). on the Toyota Tundra equipped with 3.4L Twin-Turbo V6 (V35A-FTS 389HP) / i-FORCE MAX Hybrid (437HP).

Required Tool: New OEM Gas Cap
03
Test EVAP Purge Solenoid Under Hood

Disconnect electrical plug and vacuum hose. Apply 12V; verify valve seals tight when unpowered. on the Toyota Tundra equipped with 3.4L Twin-Turbo V6 (V35A-FTS 389HP) / i-FORCE MAX Hybrid (437HP).

Required Tool: 12V Probe, Vacuum Pump
04
Inspect EVAP Canister Vent Valve Near Gas Tank

Check vent valve for road salt corrosion or spider nest clogs. on the Toyota Tundra equipped with 3.4L Twin-Turbo V6 (V35A-FTS 389HP) / i-FORCE MAX Hybrid (437HP).

Required Tool: Flashlight, Jack Stands
05
Smoke Test EVAP System

Pump mineral oil smoke into EVAP port to reveal any hairline cracked lines. on the Toyota Tundra equipped with 3.4L Twin-Turbo V6 (V35A-FTS 389HP) / i-FORCE MAX Hybrid (437HP).

Required Tool: EVAP Smoke Machine

4. Toyota Tundra P0455 FAQs

What causes code P0455 to trigger on a Toyota Tundra?

On the Toyota Tundra (3.4L Twin-Turbo V6 (V35A-FTS 389HP) / i-FORCE MAX Hybrid (437HP)), P0455 is most frequently caused by Missing, loose, or cracked gas cap seal or Faulty EVAP purge control solenoid. Factory sensor degradation or wiring harness wear near the engine bay are common factors.

Can I safely drive my Toyota Tundra with code P0455?

Yes. Completely safe to drive, but emissions test will fail. Given that P0455 carries a Low severity rating on Toyota vehicles, we advise performing diagnostic scanning via the OBD-II port located driver side lower dash assembly near parking brake before extended highway driving.

Where is the diagnostic port located on the Toyota Tundra?

The 16-pin OBD-II DLC connector on the Toyota Tundra is situated driver side lower dash assembly near parking brake. It requires no special tools to plug in a standard scanner.

How much does it cost to fix P0455 on a Toyota Tundra?

DIY replacement parts typically range between $15 - $250 (DIY: $15 - $50). If serviced at an authorized Toyota dealership, expect an additional $120–$250 in professional labor based on their $110/hr hourly rate.