MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0137 on Volkswagen ID.4

O2 Sensor Circuit Low Voltage (Bank 1 Sensor 2)

Factory diagnostic protocol and troubleshooting wire for fault code P0137 specifically for the Volkswagen ID.4 (2021–2026, Single RWD (201HP) / Dual Motor AWD ID.4 GTX (295HP / 77 kWh)).

Verified OEM Telemetry & Field Repair Tree
Volkswagen ID.42021–2026
Volkswagen ID.4
EVSingle RWD (201HP) / Dual Motor AWD ID.4 GTX (295HP / 77 kWh)
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
ID.4 SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Drivable (Short Trip)
Low urgency level
Est. Repair Cost
$100 - $300 (DIY: $35 - $100)
Parts & Labor DIY
Check P0137 On Another Volkswagen Model:
Diagnose P0137 on Specific ID.4 Model Year:

1. Symptoms of P0137 on Volkswagen ID.4

When the Engine Control Module (ECM/PCM) on your Volkswagen ID.4 (Single RWD (201HP) / Dual Motor AWD ID.4 GTX (295HP / 77 kWh)) logs fault code P0137, drivers commonly observe:

Check Engine Light on on Volkswagen ID.4 (Single RWD (201HP) / Dual Motor AWD ID.4 GTX (295HP / 77 kWh))
Downstream sensor voltage consistently below 0.15V on scan tool on Volkswagen ID.4 (Single RWD (201HP) / Dual Motor AWD ID.4 GTX (295HP / 77 kWh))
Failed emissions test on Volkswagen ID.4 (Single RWD (201HP) / Dual Motor AWD ID.4 GTX (295HP / 77 kWh))
Volkswagen ID.4 OBD-II Port Location
The 16-pin diagnostic connector is located Driver side footwell lower instrument interface. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Volkswagen ID.4

Historical warranty claims and technical repair bulletins for Volkswagen ID.4 point to the following failure distribution:

55%
Exhaust leak upstream of or directly at the Sensor 2 bung letting in fresh air (Volkswagen OEM Part)
25%
Faulty downstream oxygen sensor (Volkswagen OEM Part)
12%
Short to ground in sensor signal wire (Volkswagen OEM Part)
8%
Extremely lean exhaust condition (Volkswagen OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Volkswagen ID.4.

3. Step-by-Step DIY Repair Guide for Volkswagen ID.4

01
Inspect Exhaust System for Leaks

Listen for exhaust ticking or black soot around flex pipe, flanges, and sensor bungs before the catalytic converter. on the Volkswagen ID.4 equipped with Single RWD (201HP) / Dual Motor AWD ID.4 GTX (295HP / 77 kWh).

Required Tool: Flashlight, Jack Stands
02
Check Sensor Signal Voltage with Scan Tool

Monitor B1S2 voltage. Snap the throttle to enrich mixture; voltage should briefly spike above 0.8V. If it remains 0.0V–0.1V, sensor is defective or shorted. on the Volkswagen ID.4 equipped with Single RWD (201HP) / Dual Motor AWD ID.4 GTX (295HP / 77 kWh).

Required Tool: OBD-II Scanner
03
Replace Downstream O2 Sensor

Unplug harness, remove old sensor with 7/8 socket, install replacement sensor and plug firmly. on the Volkswagen ID.4 equipped with Single RWD (201HP) / Dual Motor AWD ID.4 GTX (295HP / 77 kWh).

Required Tool: O2 Sensor Socket, Ratchet
04
Clear Codes

Clear DTCs and verify B1S2 holds steady between 0.45V and 0.75V during steady highway cruising. on the Volkswagen ID.4 equipped with Single RWD (201HP) / Dual Motor AWD ID.4 GTX (295HP / 77 kWh).

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Volkswagen ID.4 (P0137)

Prime Fast Delivery & Verified Fitment
Direct-Fit Replacement Part

Volkswagen ID.4 OEM Replacement Sensor

4.7 / 5.0 (Verified Fit)

Direct-fit replacement assembly engineered to OEM tolerances for Volkswagen ID.4.

$45 – $95 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Volkswagen ID.4Verified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Volkswagen ID.4

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Volkswagen ID.4:

4. Volkswagen ID.4 P0137 FAQs

What causes code P0137 to trigger on a Volkswagen ID.4?

On the Volkswagen ID.4 (Single RWD (201HP) / Dual Motor AWD ID.4 GTX (295HP / 77 kWh)), P0137 is most frequently caused by Exhaust leak upstream of or directly at the Sensor 2 bung letting in fresh air or Faulty downstream oxygen sensor.

Where is the OBD-II port located on my Volkswagen ID.4?

On the Volkswagen ID.4, the 16-pin DLC diagnostic connector is located Driver side footwell lower instrument interface. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Volkswagen ID.4 with code P0137?

Yes. Vehicle is fully drivable, but Check Engine Light will remain illuminated. Given that P0137 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.