P0139 on Volvo S60
Factory diagnostic protocol and troubleshooting wire for fault code P0139 specifically for the Volvo S60 (2020–2026, 2.0L B5 (247HP) / T8 Recharge PHEV (455HP AWD)).
1. Symptoms of P0139 on Volvo S60
When the Engine Control Module (ECM/PCM) on your Volvo S60 (2.0L B5 (247HP) / T8 Recharge PHEV (455HP AWD)) logs fault code P0139, drivers commonly observe:
2. Most Likely Causes on Volvo S60
Historical warranty claims and technical repair bulletins for Volvo S60 point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Volvo S60
Use scanner graphing mode. Perform rapid deceleration fuel cutoff. Sensor should drop quickly to 0.1V. If response lags by several seconds, sensor is worn. on the Volvo S60 equipped with 2.0L B5 (247HP) / T8 Recharge PHEV (455HP AWD).
Install new OEM downstream oxygen sensor to restore fast switching response. on the Volvo S60 equipped with 2.0L B5 (247HP) / T8 Recharge PHEV (455HP AWD).
Clear DTCs and drive at 55 mph for 10 miles to set readiness monitors. on the Volvo S60 equipped with 2.0L B5 (247HP) / T8 Recharge PHEV (455HP AWD).
Equipment for Diagnosing Volvo S60 (P0139)
Volvo S60 OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Volvo S60.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Volvo S60
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Volvo S60:
4. Volvo S60 P0139 FAQs
What causes code P0139 to trigger on a Volvo S60?
On the Volvo S60 (2.0L B5 (247HP) / T8 Recharge PHEV (455HP AWD)), P0139 is most frequently caused by Aged and degraded downstream O2 sensor coated in carbon / silicon deposits or Exhaust leak near downstream sensor.
Where is the OBD-II port located on my Volvo S60?
On the Volvo S60, the 16-pin DLC diagnostic connector is located Driver lower dash trim above foot pedal cluster. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Volvo S60 with code P0139?
Yes. Safe to drive normally, but will fail emissions inspection. Given that P0139 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.