P0135 on Chevrolet: Symptoms, Causes & DIY Fix
Official technical diagnostic wire for fault code P0135 (O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 1)) specifically affecting Chevrolet vehicles (Silverado, Equinox, Malibu, Tahoe, Traverse, Colorado, Suburban, Corvette).
1. Symptoms of P0135 on Chevrolet
When the Engine Control Module (ECM/PCM) on your Chevrolet logs fault code P0135, drivers commonly observe:
2. Most Likely Causes on Chevrolet
Historical warranty claims and technical repair bulletins for Chevrolet point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Chevrolet
Locate the under-hood fuse box and test the O2 sensor heater fuse with a multimeter or test light. on Chevrolet vehicles (Silverado, Equinox).
Unplug the Bank 1 Sensor 1 connector and test resistance between the two heater pins (typically 3 to 15 ohms). on Chevrolet vehicles (Silverado, Equinox).
Use an O2 sensor socket wrench to remove the old sensor from the exhaust manifold and install an OEM-spec replacement with anti-seize on the threads. on Chevrolet vehicles (Silverado, Equinox).
4. Chevrolet P0135 FAQs
What causes code P0135 to trigger on a Chevrolet?
On Chevrolet vehicles, P0135 is most frequently caused by Burnt-out internal heating element in upstream oxygen sensor or Blown O2 sensor heater fuse. Factory sensor degradation or wiring harness wear near the engine bay are common factors.
Can I safely drive my Chevrolet with code P0135?
Yes, vehicle is safe to drive, but will stay in open-loop mode longer upon startup. Given that P0135 carries a Low to Medium severity rating on Chevrolet vehicles, we advise performing diagnostic scanning via the OBD-II port before extended driving.
How much does it cost to fix P0135 on a Chevrolet?
DIY replacement parts typically range between $80 - $240 (DIY Sensor: $45). If serviced at an authorized Chevrolet dealership, expect an additional $120–$250 in professional labor based on their $115/hr hourly rate.